Table of Contents
Advertisement
SETUP:
Q
1) Remove the quick release shoe (Q) from the tripod by pulling outward on the
lever (L). Position the telescope and the tripod so that the ¼" x 20 tripod bolt (TB)
is aligned with the tripod socket underneath the telescope tube (1). Hand-tighten
the tripod bolt by turning it clockwise. Do not over-tighten.
2) Place the quick release shoe (with the telescope attached) onto the tripod as
shown below. You will have to hold the lever (L) out while you position the
telescope. When the telescope is securely positioned push the lever (L) firmly
inward.
3) Spread the three tripod legs and set the unit down on a level surface.
4) You can adjust the height of the telescope with the leg locks (2) located
approximately half way down each leg.
Q
6
5
2
3
7
TB
L
1
L
3
4
Advertisement
Table of Contents
