PUSH AND PULL
ARM ASSEMBLY
#1502-PULLO
Figure 3. 1502-PULLO Operator Assembly
The arm has a roller attached to the end, guided by a track that is mounted on the pull side of the door.
The arm is directly mounted to the operator drive shaft.
Note: For pull to open applications the operator is mounted OPPOSITE of the door hinges.
#1502-PUSHO
Figure 4. 1502-PUSHO Operator Assembly
The angle bracket is mounted to the face of the door with fasteners, while the other end mounts
directly to the operator drive shaft.
Note: For push to open applications the operator is mounted OPPOSITE of the door hinges.
Crown Industrial Operators • 213 Michelle Ct. • So. San Francisco, Ca 94080-6202
2
Phone: (650) 952-5150 • Fax: (650) 873-1495
www.crown-industrial.com Email: autodor@crown-industrial.com
Operator 1502 is engineered to support
push, pull to open doors both left and right
directions.
Operator 1502 (Mounted to
Lintel with 6 Ea 1/2'"
Fasteners
Door
Frame
Door
Operator 1502 (Mounted to
Lintel with 6 Ea 1/2'"
Fasteners
Door
Door
Frame
G-1001