AEG SFB682E1AF User Manual page 17

Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Some specific surfaces in‐
side the fridge compartment
are warmer at some times.
Temperature setting LEDs
flash at the same time.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
The melting water outlet is
not connected to the evapo‐
rative tray below the appli‐
ance.
The "Frostmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Frostmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
An error has occurred in
measuring the temperature.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
ENGLISH
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off "Frostmatic func‐
tion" manually, or wait until
the function deactivates au‐
tomatically to set the temper‐
ature. Refer to "Frostmatic
function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "Frostmatic func‐
tion" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
This is a normal state.
Contact the nearest Author‐
ised Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.
17