Advertisement
Table of Contents
Name:
Model No.:
Operation Frequency:
Channel Numbers:
Modulation Type:
Antenna Type:
Antenna Gain:
Power Supply:
Function introduction:
1 button (arming), 2 button (disarming); press each button once, remote
control code for 1.5 seconds.
NOTE：
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
User manual
ALARM REMOTE CONTROL
Model: GD-F02D
ALARM REMOTE CONTROL
GD-F02D
433.92MHz
1
GFSK
PCB Antenna
-2.0dBi
DC3.0V from battery
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Black Widow Security GD-F02D
- Page 1 User manual ALARM REMOTE CONTROL Model: GD-F02D Name: ALARM REMOTE CONTROL Model No.: GD-F02D Operation Frequency: 433.92MHz Channel Numbers: Modulation Type: GFSK Antenna Type: PCB Antenna Antenna Gain: -2.0dBi Power Supply: DC3.0V from battery Function introduction: 1 button (arming), 2 button (disarming); press each button once, remote control code for 1.5 seconds.
- Page 2 user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Need help?
Do you have a question about the GD-F02D and is the answer not in the manual?
Questions and answers