Advertisement
Quick Links
Advertisement
Summary of Contents for Steinberg Amped Elektra
- Page 1 Operation Manual...
- Page 2 The information in this document is subject to change without notice and does not represent a commitment on the part of Steinberg Media Technologies GmbH. The software described by this document is subject to a License Agreement and may not be copied to other media except as specifically allowed in the License Agreement.
- Page 3 Table of Contents Amped Elektra Instrument Page Effects Page Index Amped Elektra 1.0.0...
- Page 4 The user interface of Amped Elektra is divided into two pages: Instrument and Effects. Instrument Page The Instrument page gives you control over all parameters that affect the sound of the instrument.
- Page 5 You can use the clean, unprocessed signal or choose between three re-amped signals that were recorded in parallel. The amplifiers were selected carefully to create a wide spectrum of sound colors for all different kinds of music genres. Delivers the clean, unprocessed sound from the instrument. On/Off Activates/Deactivates the signal. Amped Elektra 1.0.0...
- Page 6 Level Sets the level of the signal. NOTE The Level setting determines how pronounced the Bark, Release, and Pedal sounds for that signal are in the overall sound. Amped Elektra 1.0.0...
- Page 7 Here, the signal was re-amped using another well-known tube amplifier from the 1970s. Its sound is captured with a tube-condenser microphone. This is the signal with the brightest sound. On/Off Activates/Deactivates the signal. Solo Solos the signal. Amped Elektra 1.0.0...
- Page 8 Instrument page. You can add up to four effects. The signal travels through the effects in the order in which they are arranged on this page, from left to right. RELATED LINKS Available Effects on page 9 Amped Elektra 1.0.0...
- Page 9 On the effects menus for the four effect slots, you can choose between the available effects. Each effect can only be used once in the effect chain. Once an effect is selected, it is removed from the effects menu for the other effect slots. Amped Elektra 1.0.0...
- Page 10 Sets the amount of cut or boost for the high frequency band. The center frequency for this band is 5000 Hz. Chorus This effect thickens and broadens the sound by means of pitch modulation. On/Off Activates/Deactivates the effect. Amped Elektra 1.0.0...
- Page 11 Adds resonances to the effect. This allows for jet-like sweeps of the sound. Tone Adjusts the tone color of the feedback. At lower values, the feedback is less bright. Sets the ratio between the dry and the wet signal. Amped Elektra 1.0.0...
- Page 12 Widens the sound image of the effect from mono to stereo. High Cut Attenuates the high frequencies. Sets the ratio between the dry and the wet signal. Tremolo This effect produces amplitude modulation, that is, cyclic modulation of the level of the sound. Amped Elektra 1.0.0...
- Page 13 High-pass filter with 6 dB/oct. Frequencies below the cutoff are attenuated. Low-Pass Cutoff Low-pass filter with 6 dB/oct. Frequencies above the cutoff are attenuated. Distortion Adds distortion to the signal. Sets the ratio between the dry and the wet signal. Amped Elektra 1.0.0...
- Page 14 2 dB. If the amplitude is 8 dB above the threshold, the output is lowered by 4 dB. Input Determines the compression amount. The higher the input gain, the more compression is applied. Output Sets the output gain. Amped Elektra 1.0.0...
- Page 15 0.5 means that the amount is half the overall feedback. ● To offset the left feedback, turn the control to the left. ● To offset the right feedback, turn the control to the right. High Freq Attenuates the high frequencies of the delays. Amped Elektra 1.0.0...
- Page 16 Controls the reverb time. At a setting of 100 %, the impulse response is applied with its original length. Sets the ratio between the dry and the wet signal. Ring Modulator This effect provides a sine oscillator that is multiplied with the input signal. This creates metallic, or bell-like, frequencies. Amped Elektra 1.0.0...
- Page 17 This effect emulates the well-known analog pedal effect. On/Off Activates/Deactivates the effect. Mode Allows you to choose between three predefined modes with different characteristics for the effect. Depth Determines the intensity of the effect. Distortion Adds distortion to the signal. Amped Elektra 1.0.0...
- Page 18 Index Bark Effects Adding Auto Wah Chorus Compressor Delay Distortion Flanger Phaser Reordering Reverb Ring Modulator Signal chain Tremolo Effects page Extended Range Instrument page Pedal Release Sound parameters Sound sources Amped Elektra 1.0.0...
Need help?
Do you have a question about the Amped Elektra and is the answer not in the manual?
Questions and answers