Pandora BT-02 Installation Manual

INSTALLATION MANUAL
!
BEFORE STARTING THE INSTALLATION, THE RADIO RELAY MUST BE PAIRED WITH THE SYSTEM,
CONFIGURATED AND CHECKED.
The radio relay is designed for a hidden installation in the interior or engine compartment of a vehicle with
on-board voltage of +12V. While installing the relay:
- do not shield the relay (minimum distance of 20 mm between the relay and metal parts);
- provide a rigid fastening to the car body or the xed wirings (it is forbidden to hide the module
in the exible wiring);
- install the relay in places where there are no any liquids, condensate and high temperatures.
The relay must be installed with wires down, each wire must be insulated, excluding the tension of the
connection points.
• WIRE 1 I POWER SUPPLY +12V — The wire should be connected to a reliable conductor with a
constant voltage of +12V.
• WIRE 2, 3 I IN BT1(-), IN BT2(-) — the wires of the programmable input channels. They are con g-
ured and operate according to the programmed in the system logic. Inputs logic IN BT1, IN BT2 must be
assigned in the "Inputs" or "Time channels" menu.
• WIRE 7 I GROUND (-) — This wire must be connected to the grounded spot of a vehicle.
• WIRE 8 I LIN/PROGRAMMABLE channel — The wire must be connected to the wire
procedure (see "PROGRAMMING" section). It can be used for management of the engine preheater. Go to
the "Automatic start"->"Engine preheater"->"Use LIN RHM to control engine preheaters" menu and choose
Webasto or Eberspacher option (This setting will also apply to the RHM-03BT module, if installed).
• WIRES 4/ 5/ 6/ 9/ 10/ 11 I CH BLE R1 — the wires of the built-in synhronized relays with two
full groups of contacts. The built-in relays are con gured and operate according to the programmed in the
system logic. Output's logic BLE R1 must be assigned in the "Outputs" or "Time channels" menu.
!
THE SWITCHING CURRENT OF THE BUILT-IN RELAY SHOULD NOT EXCEED 1A FOR A CONTINUOUS
LOAD AND 2A FOR SWITCHING WITHOUT AN INDUCTIVE LOAD.
Customer support:
support@pandorainfo.com
Product is in conformity with Electromagnetic Compatibility
Directive EMC 2004/108/EC and R&TTE Directive 1999/5/EC
The quality management system
of the manufacturer is certi ed
in accordance with IATF 16949: 2016,
ISO 9001:2015
7 during pairing
V 1.0