Blitz SBC i-D Instruction Manual

* This system is designed to change the boost pressure of
turbocharged vehicles and does not give or reduce fuel to the
vehicle. Some cars may need a fuel cut device.
* Read this manual carefully before installing and using this system.

About the system

* This system contains a display, controller, and a solenoid unit.
* The controller is a compact 1/2 din size.
* LCD display can be seen easily during day or night.
* There are 4 individual boost pressure settings.
* This system has a boost gauge, peak hold function, scramble
Boost function, and a warning device.
* The two solenoid set gives this unit a better response, and is
capable of holding high boost pressure.
* This unit sets off a warning beep when boost pressure is close to
desired boost setting.
* Switching from wastegate to actuator can be done in controller.

WARNING

* This device is to change boost pressure but does not give or
reduce fuel to the vehicle.
* Boost controller does not go below the stock boost pressure.
* Check the parts list to make sure you are not missing any parts
to this device.
* Too much boost or not enough fuel pressure can cause damage
to engine and vehicle. Be careful and make sure that the vehicle
sufficient fuel pressure for desired boost setting. We are not
responsible for damage to the device, vehicle, or engine cause
by improper tuning.
* IMPORTANT! The product from Blitz Performance Products has
been designed and intended for off road applications. Some
products are legal for sale and use only on racing vehicles, which
may never be driven on the public highway.
* Do not try to install this device on a hot engine. Please take this
unit to a qualified installer.
Instruction Manual
Display unit Rec / Stop
Enter button
Menu button
solenoid unit
Page 1