NightStick XPP-5456 Operating Instructions

Operating Instructions for
XPP-5456 and XPP-5458
Safety Rated Intrinsically Safe Headlamps
INS-5456-12B
Thank you for purchasing this Nightstick product. Save this instruction.
Please read these instructions before using your Nightstick. It includes important safety
and operation information.
USE ONLY 3 AA ALKALINE, DURACELL PC1500, ENERGIZER EN91, OR
ENERGIZER LITHIUM L91 BATTERIES. LITHIUM BATTERIES MUST BE REPLACED
BY QUALIFIED TECHNICIAN ONLY
MODELS XPP-5456 AND XPP-5458 ARE APPROVED FOR USE
cETLus Listed Intrinsically Safe for use in Class I II III Div 1 SECRURITE INTRINSEQUE
Groups A,B,C,D,E,F & G Hazardous Locations
-20C < Tamb <+40C • Ex ia IIC T3 Ga • Class 1 Zone 0 • AEx ia IIC T3 Ga, Zone 20 •
AEx ia IIIC T 165C Da
SPECIAL INSTRUCTIONS FOR INTRINSICALLY SAFE MODELS
For personal safety, always confirm the rating of any known hazardous or potentially
hazardous location where the flashlight is planned to be used. These areas include fuel
storage areas below decks on boats, fuel or chemical transfer or storage facilities and
areas where the atmosphere contains chemicals or particles, such as grain, dust, or
metal powders. Areas with potentially explosive atmospheres may not be posted. If
you are unsure of the environment contact the Safety Director or agency where the
environment in question is located. A listing of the rated classes, divisions, groupings and
zones of gasses, vapors and combustible materials is available in the National Fire
Protection Administration (NFPA) Classification of Flammable Liquids and Combustible
Materials section of the 2004 edition of the NFPA-70 manual. Available at www.nfpa.org
Besides the batteries, there are no user serviceable components in the flashlights
SAFETY
CAUTION BRIGHT LED RADIATION: AVOID DIRECT EYE EXPOSURE. Nightstick IS
A CLASS 2 LED PRODUCT PER IEC 60825-1 EDITION 1.2.2001.
 Do not attempt to repair or disassemble the internal lighting module.
 Using this Nightstick product for other than a lighting device is not recommended.
Bayco specifically disclaims liability for other than intended use.
OPERATION
Tilt Adjustment
The headlamp light pivots on a ratchet. Adjust the tilt angle of the light to illuminate the
desired vision area.
BAYCO • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 00+1+ 469-326-9400 • www.baycoproducts.com
XPP-5456 and 5458
Both models have two switches to control the spotlight and the white and colored
floodlights. The flashlight and floodlight functions can be operated independently or
together.
Spotlight Operation
To turn on the spotlight, press the spotlight switch. Press again to turn off.
Floodlight Operation
The floodlight switch controls 3 floodlight functions.
First Press: White floodlight on - full power
Second Press: White floodlight on half-power
Third Press: White floodlight off - colored LED floodlight on.
Fourth Press: Floodlight function off.
CAUTIONS
 Warning – Substitution of Components May Impair Intrinsic Safety.
 AVERTISSEMENT : LA SUBSTITUTION DE COMPOSANTS PEUT
COMPROMETTRE LA SECURITE INTRINSEQCJE
 Warning To reduce the risk of explosion do not mix new batteries with old/used
batteries, or mix batteries from different manufacturers
 Warning To reduce the risk of ignition of a flammable or explosive atmosphere,
batteries must be changed only in a location known to be non-hazardous
 AVERTISSEMENT: AFIN DE PREVENIR L'INFLAMMATION D'ATMOSPHERES
DANGEREUSES, NE CHANGER LES BATTERIES QUE DANS DES
EMPLACEMENTS DESIGNES NON DANGEREUX
 WARNING: Risk of ignition – Do not open in a hazardous area
HEADBANDS
The headlamps include two types of headbands
Elastic Non-Slip Headband. Use this headband for mounting the headlamp directly to
your head. The Non-slip feature will keep the light positioned on the head even with
vigorous movement.
Rubber Hardhat Strap Use the rubber strap on any hardhat. The tacky nature of the strap
will keep the headlamp attached even if the hat is dropped.
INSTALLING OR CHANGING BATTERIES
CAUTION
ATTENTION
PRECAUCIÓN
TO REDUCE THE RISK OF IGNITION OF A FLAMMABLE OR EXPLOSIVE
ATMOSPHERE, BATTERIES MUST BE CHANGED ONLY IN A LOCATION KNOWN
TO BE NON-HAZARDOUS
1. Loosen the battery door screw located on the back of the battery pack.
2. Install 3 AA batteries in the pack. Use only approved batteries: Duracell PC1500,
Energizer EN91, or Energizer Lithium L91
3. Close the battery pack door and tighten the door screw.