Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for JMC JMC-OSPH-SS
- Page 2 PLEASE READ THE FOLLOWING SAFETY Read all of these instructions before ADVICE PRIOR TO THE OPERATION OF THIS installation and use. HEATER If you smell gas: • This appliance must be installed and the gas cylinder stored in accordance with 1.
-
Page 3: Table Of Contents
SAFETY PRECAUTIONS TABLE OF CONTENTS Read the instructions before using this appliance. The appliance must be installed in Safety Precautions …………………………………………………… 4 accordance with the instructions. Heater Stand and Location …………………………………………… 6 Gas Requirements …………………………………………………… 6 Do not use this patio heater indoors, as it may cause personal injury or property Leak Test ………………………………………………………………... -
Page 4: Heater Stand And Location
HEATER STAND AND LOCATION The gas cylinder should only be changed in a ventilated area, away from sources of The heater is primarily for outdoor use only. Always ensure that adequate fresh air ignition (candles, cigarettes, and other flame producing appliances) ventilation is provided. -
Page 5: Leak Test
Leak Test OPERATION AND STORAGE Gas hose connections on the heater are leak tested at the factory prior to shipment. A complete gas leak check must be performed at the installation site due to possible mishandling during the transit process. Off: the heater stop work Hi: maximum temperature position Lo: minimum temperature position... -
Page 6: Cleaning And Care
CLEANING AND CARE CONSTRUCTION AND CHARACTERISTICS • Wipe off surfaces with soft, moist cloth. Do not clean the heater with cleaning • Transportable terrace/garden heater with cylinder housing. products that are combustible or corrosive. • Constructed with aluminium, powder coated and stainless steel •... -
Page 7: Assembly Parts
ASSEMBLY PARTS Hardware Contents Tools needed: M6 nut • Philips screwdriver w/ medium blade Bolt M6x10 Screw M5x10 Stud Wing nut Flat washer Qty.4 Qty. 16 • Spray bottle of soap solution for leakage test Qty. 4 Qty. 3 Qty. 3 Qty. -
Page 8: Assembly Procedure
Assembly Procedure 1.Assemble the wheel assembly (M) to the 3. Insert upper support (D) to lower support bottom plate (N) using 4pcs bolt M6x10 (L) using 8pcs screw M5x10. (AA) and 4pcs M6 nut (BB). Assemble top plate assy (B) to upper support (D) using 8pcs screw 3/16”. - Page 9 5. Carefully install the glass tube (C) by 7. Assemble three side panels (G) to heater lifting up and inserting through the center using 18pcs screw 3/16”. hole in the top plate assy (B). Ensure the black silicone ring (F) is attached to the Attention: lower edge of the glass tube (C) as illustrated.
-
Page 10: Troubleshooting
LEAK TEST Please ensure you follow the procedure on page 7 before operating the heater. TROUBLESHOOTING Problem Probable Cause Suggested Solution Gas regulator may be Turn the regulator ON Gas cylinder empty Replace with full cylinder Pilot will not light Opening blocked Clean or replace opening Air in supply system...
Need help?
Do you have a question about the JMC-OSPH-SS and is the answer not in the manual?
Questions and answers