Coopers of Stortford 10710 Instructions For Use

Wireless Telephone Signaller
Please read and retain these instruc ons for future reference
The wireless Telephone Signaller is to be used in conjunc on with Wireless Receiver with Doorbell - Item
code 10708.
PARTS & FUNCTION
Test
Telephone
Plug RJ11
CODE PAIRING & MELODY SELECTION
The WIRELESS TELEPHONE SIGNALER works with the receiver
and must be paired prior to use.
Step 1: Insert the ba ery into the telephone transmi er.
Step 2: Insert the ba eries into the receiver (chime unit).
Step 3: Enter pairing mode for the receiver (chime unit). Press &
hold the ● zone selector bu on for 3 seconds. The LED in
zone #1 will flash.
Step 4: Press the ● zone selector bu on again to move to the zone
you wish to pair with. Press the ♫ melody selector bu on
to scroll through the melodies. Once you hear a melody
you prefer, do not press any bu on as the melody is set for
that zone.
Step 5: Once the zone and melody are selected, press the test bu on on the telephone signaler once. If
successful, the receiver will generate a short tone. Press the ● zone selector bu on to exit pairing
mode unit is now ready to use.
Alert Reset Bu on
To cancel any alert on the remote receiver press the reset button. The reset button is located on
the back of the receiver behind the flasher.
OPERATION
Plug the telephone line into the telephone RJ11 jack refer to the diagram. The system is now ready to use.
*Calls Cost 7 pence per minute plus your telephone company's network access charge
Battery
compartment
Uses CR2032 Battery
Instruc ons for Use
10710
BATTERY INSTALLATION
Open the cover
Zone ID
Zone selector button
Melody selector
button
Head Office, 11 Bridge Street
Bishop's Stor ord CM23 2JU
Tel: 0844 482 4400*
Fax: 01279 756595
www.coopersofstor ord.co.uk
v001: 23/11/16
Insert a CR2032
Ba ery (included)
Chime only
Chime/Strobe
Strobe only
OF STORTFORD