XTA MC2 Programming Manual

Dpanel8 Short form Programming Guide
x ta
KEY KEY
1 5
KEY KEY
2 6
KEY KEY
3 7
KEY KEY
4 8
PROGRAMMABLE REMOTE PANEL PRP-200

Introduction

Welcome to the short programming guide for the XTA / Mc2 D-Panel8.
This short guide gives an overview how to program the Dpanel8.
The panel configuration is designed using the control software downloadable below
https://audiocore.wpengine.com/wp-content/uploads/2019/04/DPanel-Utilities.zip
The software is pictured at the top of this page :
The design files this software creates is an *.xtawpnl file.
To program the wall panel it needs connecting to a Mc2 delta dsp
or XTA DPA amplifier.
Please ensure
1) an ethernet connection from PC to the amplifier is made.
2) The amplifier interface is set to `ethernet`
Please see the wiring guide on page 2,
This shows how your panel needs connecting to your amplifier.
This connection works for both programming and panel control.
The standard XTA loader is then used to load the *.xtapnl file.
Page 1 of 2
RELAY
& `Rs485 mode` is set to `simple` & `115200`.