m a i n t e n a n c e
—
Replacing the battery on the ArcSwitch®
05
transmitter
Replacing the battery
in the ArcSwitch®
• Upon activation of transmitter button and the
Transmitter
battery LED flashes you should replace the
batteries.
• Make sure the ArcSwitch® meter is switched off
and it is not connected to a circuit.
• Turn the ArcSwitch® Transmitter over and
unscrew the 6 screws and remove the Back
cover see (fig 5.)
• Then remove 2 black screws and lift off battery
door.
• Replace the 3 x AAA batteries with new
batteries of the same make and pay attention to
the polarity and that the cables do not get
damaged.
• Replace the battery door and tighten the 2 black
screws.
• Replace the 6 screws and make sure the cables
do not get pinched by the back cover.
• Turn the ArcSwitch® meter on and test the
contacts are opening and closing when
commanded by the ArcSwitch® Transmitter.
• If you are storing the ArcSwitch® meter for an
extended period, you should remove the
batteries to prevent damage due to possible
leaking of the electrolyte on to the electronic
components inside.
—
05
15