Advertisement
Advertisement
Table of Contents
Related Manuals for Jedia JTP-10RDS
Summary of Contents for Jedia JTP-10RDS
- Page 1 AM/FM DIGITAL R.D.S TUNER JTP-10RDS...
- Page 2 UNER CONTROLS JTP-10RDS FM / AM / RDS TUNER 1. TUNER ON SWITCH This switch is used for supplying the power to tuner and display 2. UP AND DOWN SWITCH When these switches are pressed one time, FM/AM frequency is up or down with one step, and in case of pressing over 2secdonds, the mode will change to "Auto scan"...
- Page 3 UNER CONTROLS JTP-10RDS 5. BAND SELECTOR FM, AM This switch is user for selecting FM1, FM2 or AM. 6. MUTE BUTTON MUTE on/off control button When "MUTE"is displayed onLCD panel, all outputs are muted 8. A/PS BUTTON (AME/PSCAN) Preset memory scan auto store memory button.
- Page 4 PECIFICATIONS FM RECEIVING ANTENNA This electric wave of FM broadcasting is weakening in hill and valleys, around buildings and in iron-reinfroced buildings because if it’s own INSTALLATION OF ANTENNA EXCLUSIVELY FOR FM Connect the feeder of the antenna to the terminal of 300ohm(Fig1-1)listening to the broad- casting, fix it after deciding the location and the direction so that the recipt condition may be optimum INSTALLATION OF ANTENNA EXCLUSIVELY FOR FM...
- Page 5 ONNECTION OF THE ANTENNA AND THE EARTHING CABLE AM LEAD ANTENNA Fix one-side to AM termianl and the other to high place like a wall after marking the vinyl-coated cable of a sigle cable about 6-8m long (Fig 1-2) AM OUTDOOR ANTENNA Install the vinyl-cated cable at the outdoor place in case you cannot quite well through you have installed the lead antenna.(Fig 1-2) ONE EARTHING (EARTH GND)
- Page 6 ONNECTION OF THE ANTENNA AND THE EARTHING CABLE ■ TUNER SECTION ● Tuning range FM87.5 ~ 108MHz ● ANT input ● FM : 300Ω balanced or 75Ω unbalanced ● AM : High impedance lead antenna ● Usable sensitivity FM : 2uV AM : 4.5uV ●...
Need help?
Do you have a question about the JTP-10RDS and is the answer not in the manual?
Questions and answers