Table of Contents
Advertisement
DECK MECHANISM DISASSEMBLY
1. Drum Assembly (Fig. A-1-1)
1) Unplug the Drum FPC Connector.
2) Remove three Screws(S1) on bottom side and separate
the Drum assembly.
3) Unhook (H1), (H2) and separate the Holder FPC and
Cap FPC.
1-1. Drum Motor
1) Remove two Screws(S2) and disassemble the Stator of
the Drum Motor.
2) Remove two Screws(S3) and separate the Rotor of the
Drum Motor from the Drum Sub assembly.
NOTE
When reassembling, confirm (A) portion of the Drum Sub
assembly whether the Carbon Brush is in there or not.
(S2)
(S2)
(S3)
(A)
Carbon Brush
Stator
(S3)
Drum Motor
Rotor
Drum Sub Assembly
(Fig. A-1-1)
Drum FPC
(S1)
(S1)
H2
Fig. A-1
(Fig. B-1)
Holder FPC
(S1)
H1
Holder FPC
Cap FPC
Drum FPC
Figure in the opposite direction
4-2
Advertisement
Table of Contents
