Mr. Heater MH15T Operating Instructions And Owner's Manual page 3

Heater model MH15t and MH30t are packaged com
heater model.
2. Remove heater from carton.
use only vapor withdrawal lP gas cylinders constructed
dance with the specifications for lP gas cylinders of the
4. this heater must be used only with a vapor withdrawal
the heater can be attached to the propane tank.
retain for later use.
holes in center plate on manifold such that the
heater is facing outward once attached to cylinder
collar.
center plate.
tank collar. Mounting bolt knob should be posi
tioned to the outside of tank collar.
bolt knob. Do not overtighten.
possible. Do not overtighten.
35mm screw and wing nut to secure heater sup
Figure 1.
Figure 2a.
Figure 2b.
6. operate only on a stable, level surface.
7. open propane tank valve slowly.
8.
indicate a leaking connection. Correct all leaks before
proceeding.
Warning
never touch heater while in operation to avoid injury.
Move heater by grasping the propane cylinder carefully.
9. the heater should be inspected before each use and at
the hose assembly shall be visually inspected prior to
or wear, or the hose is cut, it must be replaced prior to
the heater being put into operation. Replacement hose
assembly shall be Mr. Heater hose assembly as listed in
the parts list.
Minimum inlet gas pressure is 20 psi.
ambient temperature of 75°
°