Altinex Cable-Nook Jr. CNK221 User Manual

CNK221/241/261
Welcome!
We greatly appreciate your purchase of the Cable-Nook Jr.
Interconnect Box. We are sure you will find it reliable and simple
to use. Superior performance for the right price, backed by solid
technical and customer support is what Altinex has to offer.
We are committed to providing our customers with Signal
Management Solutions® to the most demanding audiovisual
installations at competitive pricing and we welcome you to join the
ranks of our many satisfied customers throughout the world.

1. Precautions and Safety Warnings

Please read this manual carefully before using your Tabletop
Cable-Nook Jr. Interconnect Box. Keep this manual handy for
future reference. These safety instructions are to ensure the long
life of your Cable-Nook Jr. and to prevent fire and shock hazard.
Please read them carefully and heed all warnings.
1.1 General
•
Qualified Altinex service personnel, or their authorized
representatives must perform all service
1.2 Installation Precautions
•
For best results, place the Tabletop CNK Jr.
Interconnect Box in a dry area away from dust and
moisture.
•
To prevent fire or shock, do not expose this unit to water
or moisture. Do not place the Tabletop Cable-Nook Jr.
Interconnect Box in direct sunlight, near heaters or heat-
radiating appliances, or near any liquid. Exposure to
direct sunlight, smoke, or steam can harm internal
components.
•
Handle carefully and never lay the CNK Jr. on the thin
bezel. Dropping, jarring, or striking may damage the
bezel.
•
Never place fingers inside the openings in the sides of
the unit or along the bezel edges. The sharp edges may
cause serious injury.

2. Installation Procedures

CAUTION: Do not handle the unit by the bezel's thin lip or lay it on its side. The thin bezel is very sharp and can be easily dented or
bent. Handle by the housing portion only.
Step 1. Cut an opening in the table's surface. Refer to
table cutout dimensions and templates. The tabletop thickness must
be 3 in [76 mm] or less. Always confirm dimensions before cutting to
ensure that the specifications have not changed.
Step 2. If needed, adjust the interior bracket mounts to the level you require
by removing the two screws securing each bracket to the interior
housing. Make sure both sides are at the same level.
Step 3. Insert the Cable-Nook Jr. unit into the tabletop cutout. Place a
mounting bracket with the thumbscrew installed into the support
mounts on each side of the housing as shown. With the mounting
brackets installed, turn the thumbscrews until the ends of the screws
begin to push against the bottom of the table. Tighten the screws
until the unit is secure. Do not over-tighten.

3. Limited Warranty/Return Policies

Please see the Altinex website at
400-0133-008
Cable-Nook
www.altinex.com
www.altinex.com for details on warranty and return policies.
®
Jr.
•
Tabletop cutout dimensions and templates can be
obtained from the Altinex website at www.altinex.com.
1.3 Cleaning
•
Surfaces should be cleaned with a dry cloth. Never use
strong detergents or solvents, like alcohol or thinner. Do
not use a wet cloth or water to clean the unit.
1.4 FCC Notice
•
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
•
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions
found herein, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
•
Any changes or modifications to the unit not expressly
approved by Altinex, Inc. could void the user's authority
to operate the equipment.
for
1
User's Guide