Table of Contents
Advertisement
Installation Step 6
Install the Door Control
Locate the door control within sight of the door at a
minimum height of 5 feet where small children
cannot reach, and away from all moving parts of the
door and door hardware.
• Strip 1/4" of insulation from one end of the bell
wire; connect the wire to the two screw terminals
on the back of the door control by color: white to 2
and white/red to 1.
• Fasten the Lighted Door Control Button securely
with 6ABx1-1/2" screws. If installing into drywall,
drill 5/32" holes and use the anchors provided.
• Run the bell wire up the wall and across the ceiling
to the opener. Use insulated staples to secure the
wire in several places. Be careful not to pierce the
wire with a staple, thereby resulting in a short.
• Receiver terminal screws and the antenna are
located on the back panel of the opener. Position
the antenna wire as shown.
• Then connect the bell wire to the opener terminal
screws: white to 2 and white/red to 1.
• Attach the User Safety Instruction label to the wall
near the door control, and the Maintenance
Instruction Label in a prominent location on the
inside of the garage door.
Page 32 explains how to use the door control.
Hardware Shown Actual Size
6ABx1-1/2" Screw
Lighted Door Control Button
Insulated
Staples
Dry Wall Anchors
Lighted
Door Control
Button
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause serious
injury or death.
Install the Door Control (or any additional push
buttons) out of the reach of children and away
from all moving parts of the door and door
hardware, but where the garage door is visible.
Do not allow children to operate the push
button(s) or the remote control transmitter(s).
A moving garage door could injure someone
under it. Activate the opener only when the
door is properly adjusted, you can see it clearly,
and there are no obstructions to door travel.
Do NOT connect the power and operate the
opener at this time. The trolley will travel to the
full open position but will not return to the close
position until the sensor beam is connected and
properly aligned. See Safety Reversing Sensor
Instructions beginning on page 21.
2-Conductor
Bell Wire
Back Panel
18
WARNING
2-Conductor
Bell Wire
-2
-1
Lighted Door
Control Button
Terminal Screws
Opener
Terminal
Screws
1
2
9
7
Antenna
of Opener
3
1
9
1
3
7
3
5
5
KG
KG
Advertisement
Table of Contents
