Stelpro RM347C Series Installation

RELAY INSTALLATION
RM347C SERIES
Warning
The following instructions must be adhered to in order to avoid personal and serious injury, property damage and potentially fatal electric shocks.
Before installing and operating this product, the user and/or installer must read, understand and follow these instructions and keep them handy for future reference.
If these instructions are not followed, the warranty will be considered null and void and the manufacturer deems no further responsibility for this product.
IMPORTANT: This product must be installed and connected by a certified electrician, according to electrical and building codes effective in your region.
Switch off the power at the circuit breaker/fuse before installing, repairing and cleaning the unit.
Make sure the unit is appropriate for the intended use (if needed, refer to the product catalog or a representative).
To obtain the complete relay installation procedure of a particular product, go to www.stelpro.com/pro and to the product page. The installation
procedure may be found under the "ACCESSORIES INSTALLATION GUIDE" tab.
RM347C
Important Points For Installation And Use
- Connect the relay in accordance with the installation guide available online.
- Make sure to follow the relay specifications.
- This product is not intended for fast cycling modulation. For fast cycling modulation, please use the RE series from Stelpro, which is an electronic relay
series.
- Never replace the unit's relay with a non-certified relay.
- For additional information, please contact our customer service.
Specifications
Operating temperature: -30°C to 65°C
Storage temperature: -30°C to 65°C
Control Specifications
W: 24VAC / 2.8VA required to close the relay
Class 2
Load Specifications
VOLTAGE (VAC)
120
208/240/277
347
For further information or to consult this guide online, please visit our website at www.stelpro.com
PURELY RESISTIVE LOAD
CURRENT (A)
25
25
18
L1
Charge
L2/N
Typical Wiring Diagram
L1
Load
L2/N
FULL LOAD
AMPERAGE (FLA)
14
8
RM347C
Noir
Noir
C (COM)
W (signal)
Rouge Blanc
RM347C
Black
Black
C (COM)
W (signal)
White
Red
LOCKED ROTOR
AMPERAGE (LRA)
84
48
Contrôle
Control
INSRM0516