Spinmaster PERPLEXUS STAR WARS DEATH STAR Manual page 2

GET READY TO PLAY!
ON/OFF SWITCH
If still attached, remove and discard plastic demo tab before play.
To play, move switch to "ON" position. Switch to "OFF" position after play.
I = ON
O = OFF
If the unit is stationary for 20 seconds, it will go to sleep.
The unit can be woken up by picking it up or agitating it.
BATTERY INSTALLATION
1. Open the battery door with a Phillips-head screwdriver (not included).
2. Requires 3 x AAA (LR03) batteries. Insert batteries as shown.
3. Replace the battery compartment door and tighten the screw.
Battery Safety Information: 3 x AAA (LR03) alkaline batteries (included). Batteries are small objects. Replacement of
batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead
batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the
same or equivalent type as recommended are to be used.
DO NOT incinerate used batteries.
DO NOT dispose of batteries in fire, as batteries may explode or leak.
DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard).
DO NOT use rechargeable batteries.
DO NOT recharge non-rechargeable batteries.
DO NOT short-circuit the supply terminals.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
x AAA (LR03)
Requires 3 alkaline batteries (included). Batteries are small objects. Batteries or battery packs must
be recycled or disposed of properly. When this product has reached the end of its useful life it should not be
disposed of with other household waste. The Waste Electrical and Electronic Equipment Regulations require it to be
separately collected so that it can be treated using the best available recovery and recycling techniques. This will
minimize the impact on the environment and human health from soil and water contamination by any hazardous
substances, decrease the resources required to make new products and avoid using up landfill space. Please do
your part by keeping this product out of the municipal waste stream! The "wheelie bin" symbol means that it
should be collected as "waste electrical and electronic equipment". You can return an old product to your retailer
when you buy a similar new one. For other options, please contact your local council.