Zidoo X8 Simple Manual page 2

Use the HDMI cable to connect X8 TV BOX with your TV set or projection device.
If it is an old TV, please use AV cable to connect X8 TV BOX with your TV set.
Connect the power
Remote Controller: please put the
batteries inside the RC. If you will
not use the RC for a long time,
please take out the batteries.
Pressing " " （around 8-10s）, unloosing until the light long on（red）.
"
Single-click one of the learning buttons
on this remote control, the light will flash slowly;
Turn on the TV, turn on X8 TV BOX
"
Keeping a face-to-face state with the launcher mouth of two remote controls,
distance from 1~3cm.
Pressing the learning button that you need to learn with the TV RC for several seconds,
unloosing until the light long on, when the light off, it means it's finished its learning.
If you want to learn other buttons, just repeat
" "
press to exit the learning state.
; after finishing learning;