Advertisement
5. OPERATION
WARNING! Ensure that you read, understand and apply the safety instructions in Section 1 before use.
‰
WARNING! Wear approved ear, eye, hand and respiratory protection when operating the blaster.
‰
5.1.
Attach an airline to the gun which has a 1/4" BSP fitting.
5.2.
Remove the grit container from the gun by twisting it anticlockwise until it stops, then pull it off the head. Fill the container with the
grit supplied. Align the three pins in the neck of the container with the corresponding gaps in the head flange and push the container onto
the head. Twist the container clockwise to seal it to the head.
5.3.
Ensure that the recycling bag is empty and that it is retained in place properly.
5.4.
Fit the nozzle most suited to the job to be undertaken and push it fully on to the mouth of the gun. The round nozzle is for blasting general
bodywork stone chip damage. The slotted nozzles are for blasting damage to either an external edge or internal fold.
5.5.
It is strongly advised that the action of the gun is tested first on some scrap material before proceeding to the actual workpiece.
5.6.
Place the nozzle over the damaged area and apply medium pressure in order to seal the nozzle against the bodywork. (The recycling action
will not work efficiently if the nozzle is not sealed to the body). Do not apply excessive pressure as this may cause the rubber nozzle to distort.
Partially depress the trigger to get a light feathering action on the damage. Remove the nozzle and inspect the area. Proceed as required.
Fully depressing the trigger will give the strongest blasting action.
5.7.
When work is complete, disconnect the gun from the air supply. Remove the main grit container and empty any unused grit back into a
suitable container. Loosen the neck of the recirculation bag and remove it. The recirculated grit should be finely sieved to remove any other
particles before returning it to a grit container.
6. MAINTENANCE
WARNING! Disconnect from the air supply before performing any maintenance.
‰
WARNING! Wear ear, eye, hand and respiratory protection when undertaking any maintenance.
‰
6.1.
Keep all parts of the gun clean for best performance.
DO NOT leave recirculated grit in the bag. Always completely empty bag after each use.
8
6.2.
Lubricate the plunger, between the trigger and the gun handle with a light grease.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
6.3.
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
6.4.
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
SG10E Issue:3 (H,F) 02/07/20
Advertisement
