Advertisement
1.3.
GENERAL SAFETY
WARNING! This pump must be used in accordance with Health & Safety, government, local authority and water authority rules
‰
‰
‰ ‰
and regulations including appropriate procedures for the protection of persons, animals, equipment and property.
‰ ‰ Familiarise yourself with application, limitations and potential hazards peculiar to the pump.
9
‰
‰ ‰ WARNING!‰Disconnect the pump from the mains power before changing accessories, servicing or performing any maintenance.
‰
‰
‰ ‰ WARNING!‰DO NOT have contact with the water whilst the submerged pump is connected to the mains supply.
‰
‰
‰ ‰ Maintain the pump in good condition (use an authorised service agent). Keep the pump clean.
9
‰
‰ ‰ Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
‰
‰ ‰ Switch off the power on all devices that are in contact with the water before carrying out any cleaning or maintenance work on the device.
9
‰
‰ ‰ DO NOT use the pump for any purpose other than for which it is designed.
‰ 8
‰ ‰ DO NOT operate the pump out of water. The pump pick-up area must be completely submerged during operation.
‰ 8
‰ ‰ DO NOT operate the pump during freezing temperatures. DO NOT leave the pump in water that may freeze.
‰ 8
‰ ‰ DO NOT carry the pump by its electrical cable, or outlet pipe.
‰ 8
‰ ‰ DO NOT use the device in water additionally chlorinated or in acidic or alkaline solutions. DO NOT use in salt water.
‰ 8
‰ ‰ DO NOT let the pump run dry. This can cause irreparable damage.
‰ 8
NOTE: This appliance can be used by children aged from 8 years and above, and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in
a safe way, and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
2. INTRODUCTION
Suitable for creating garden water features. Provides the important
functions of filtration and water circulation which are necessary
to maintain healthy plant and fish life. Supplied with two fountain
heads.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .WPP1100
Cable Length: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10m
Fountain Effects:. . . . . . . . . . . . . . . (A) Fountain / (B) Cascade
Maximum Submersion Depth: . . . . . . . . . . . . . . . . . . . . . . . 3m
Maximum Temperature of Pumped Fluid . . . . . . . . . . . . . .35°C
Maximum Head: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1m
Maximum Output: . . . . . . . . . . . . . . . . . . . . .1100ltr(242gal)/hr
Supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230V
Motor Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20W
Outlet Size OD: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ø13mm
Nett Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.50kg
4. OPERATION
WARNING! Ensure that you read, understand
‰
and apply the safety instructions in Section 1.
4.1.
START-UP
4.1.1.
Fit the four rubber feet to the base of the pump.
4.1.2.
Place the pump on a flat level surface which is raised from the bottom of the pond. This will prevent the pump from clogging too quickly.
4.1.3.
You may use the pump lying on its side. You should however, make sure that the motor axle is horizontal, otherwise the axle will be subject to
increased wear.
4.2.
CASCADE FOUNTAIN MODE
4.2.1.
When installing the pump in the pond,
make sure that the cascade fountain
head projects above the water
surface.
4.2.2.
Refer to (fig.1) for the maximum
delivery height and diameter.
4.3.
WATER BELL FOUNTAIN MODE
4.3.1.
Install the water bell fountain head
onto the outlet pipe.
4.3.2.
The closer the head is to the water
surface, the larger the diameter of
the water bell that can be achieved.
4.3.3.
You can adjust the volume of water
and the size of the bell by screwing
the top of the water bell head in or out
(fig.2.1).
© Jack Sealey Limited
A
B
fig.1
Water Bell Head
Cascade Fountain Head
Original Language Version
WPP1100 | Issue 6 (H,F,2,3) 28/02/2019
Advertisement
