Advertisement
Quick Links
SCOTIA LED FLOODLIGHT
(ENGLISH)
Scotia LED Floodlight Luminaire
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
Important: Please read these instructions carefully before installing or maintaining this equipment.
Good electrical practices should be followed at all times and this data should be used as a guide only.
___________________________________________________________________________________________________
I-SCOD-04.doc
Issue 03
03/02/2021
1
Advertisement
Related Manuals for Chalmit Scotia SCOD/12L/LE Series
Summary of Contents for Chalmit Scotia SCOD/12L/LE Series
- Page 1 SCOTIA LED FLOODLIGHT (ENGLISH) Scotia LED Floodlight Luminaire INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS Important: Please read these instructions carefully before installing or maintaining this equipment. Good electrical practices should be followed at all times and this data should be used as a guide only. ___________________________________________________________________________________________________ I-SCOD-04.doc Issue 03...
-
Page 2: Special Conditions For Safe Use
Shall only be installed and wired with cable in an ambient temperature of -10°C to +80°C. 1.0 Introduction – SCOTIA FLOODLIGHT The Scotia LED Floodlight Luminaire operates from mains voltage. Table 1 MODEL VARIATIONS CHALMIT MODEL WATTS VOLTS AMPS T* CLASS... - Page 3 SCOTIA LED FLOODLIGHT (ENGLISH) 3.0 Installation and Safety 3.1 General There is no health hazards associated with this product whilst in normal use. However, care should be exercised during the following operations. Installation should be carried out in accordance with ABNT NBR IEC 60079-14 or the local hazardous area code of practice, whichever is appropriate, and fitting of specified insulating material to be adhered to where a specific fire resistance rating is required.
- Page 4 SCOTIA LED FLOODLIGHT (ENGLISH) 3.3 Electrical Supplies A maximum voltage variation of +6%/-6% on the nominal is expected. The safety limit for T rating is +10%. 3.4 Light Source The luminaire is fitted with LEDS that can last 80,000 hours depending on ambient temperatures. Therefore depending on the functionality of the fitting replacement of LED’s will be rare /unnecessary.
- Page 5 (It may well be practical to also replace the gasket on each occasion if this is at a 3-year interval). (supplied by Chalmit). If painting operations have taken place around the luminaire, ensure that coatings have not entered the flameproof path or been deposited on the lampglass.
- Page 6 LED replacement. If it is necessary to replace the LED’s, the LED’s are mounted on three separate boards that can be replaced individually. (The boards with LED's supplied by Chalmit ). Removal of LED assembly is as follows: 1.
- Page 7 SCOTIA LED FLOODLIGHT (ENGLISH) Directions for Installation of Accessories Note: Reflector and Guard cannot be used simultaneously WARNING: Ensure the supply circuit is off before starting installation. To install reflector, verify that the luminaire is completely assembled. Install lens reflector on lens assembly by first hooking the top of the reflector over the top of the luminaire, lining up the holes in the reflector with the holes on the lens housing.
- Page 8 SCOTIA LED FLOODLIGHT (ENGLISH) To comply with the Waste Electrical and Electronic Equipment directive 2012/19/EU the apparatus cannot be classified as commercial waste and as such must be disposed of or recycled in such a manner as to reduce the environmental impact. ___________________________________________________________________________________________________ I-SCOD-04.doc Issue 03...