Subscribe to Our Youtube Channel
Summary of Contents for ITech IT-E190 Series
- Page 1 Current Sensor IT-E190 Series User’s Manual Model: IT-E190-6A/IT-E190-15A/ IT-E190-25A/IT-E190-40A/ IT-E190-60A Version: V1.0...
- Page 2 Notices Warranty Safety Notices © Itech Electronics, Co., Ltd. 2016 The materials contained in this No part of this manual may be document are provided “as is”, and reproduced in any form or by any means (including electronic storage and...
-
Page 3: Table Of Contents
(1). Introduction of front panel ........5 (2). Introduction of rear panel ........5 Ⅳ IT-E190 Function Introduction ........6 (1). Introduction of Front Panel Terminals ......6 (2). Connecting Current Sensor ........7 Copyright © Itech Electronics Co., Ltd. -
Page 4: Ⅰ About It-E190
IT-E190 User’s Manual Ⅰ About IT-E190 IT-E190 Series current sensor is an optional accessory provided by ITECH, which is mainly used for expanding the current measurement scope of ITS9500 power supply test system and IT9121 power meter. Features: small size, large measurement scope ... -
Page 5: Ⅲ It-E190 Appearance Introduction
(1). Introduction of front panel ① ② Input interface of power supply DB9 terminal (2). Introduction of rear panel Terminal protection cover Diagram of rear panel (when terminal protection cover is removed) is shown below: Copyright © Itech Electronics Co., Ltd. -
Page 6: Ⅳ It-E190 Function Introduction
Input voltage: 220VAC; Output voltage range: DC5V-DC9V; Output current: 1.2A (MAX); Output polarity: Internal + (Positive) External - (Negative). DB9 Terminal DB9 terminal is defined as follows: Base pin number Description +12V GND, grounding -12V Copyright © Itech Electronics Co., Ltd. -
Page 7: Connecting Current Sensor
1. When terminal protection cover at the IT-E190 rear panel is removed, connect the input terminal to the test circuit in series. Load 2. Connect the IT-E190 DB9 terminals to the current measurement terminal at the IT9501 front panel (I-Sense) through standard test lines. Copyright © Itech Electronics Co., Ltd. - Page 8 3. Connect the IT-E190 DB9 terminal to the external sensor input interface of the power meter through DB9 extension. NOTE For interface instructions of the current sensor of power meter, refer to IT9121 Installation Instructions. Copyright © Itech Electronics Co., Ltd.
- Page 9 YOUR POWER TESTING SOLUTION Contact US Thank you for purchasing ITECH products.If you have any doubt about this product, please contact us as follow. 1. Please refer to the CD-ROM of related user’s manual in package. 2. Click www.itechate.com or scan the right two-dimension code to visit the ITECH website.
Need help?
Do you have a question about the IT-E190 Series and is the answer not in the manual?
Questions and answers