Product Overview Volume Up / Previous Song Multi-Function Button Volume Down / Next Song ANC Button 3.5mm AUX port Microphone Bluetooth / ANC Indicator Charging Port...
Power On / Off Flashing red and Power On Press and hold for 3 seconds blue alternately Power Off Press and hold for 3 seconds Flashing red...
Page 7
Pairing Press and hold for 5 seconds Flashing red and blue alternately Select “Saramonic BH600” on your device Voice prompts “connected” Notes: The pairing mode will be lasted for 10 minutes. If there is no Bluetooth connection with any device for more than 10 minutes, the headphone will automatically turn off.
Button Controls Play / Pause Press ×1 Next Tack Press and hold for 3 seconds Previous track Press and hold for 3 seconds Volume up Press ×1 Volume down Press ×1 Answer / End a call Press ×1 Reject a call Press ×2 Call the latest number Press ×2...
Page 9
Aux-in Switching to AUX mode once plugging in an audio cable, and Bluetooth mode will automatically turn off. When using AUX mode, control audio playback, volume and call via the connected device.
Page 10
ANC On / Off Bluetooth / ANC Indicator ANC On Slide the switch to ON Steady green(NC LED indicator) ANC Off Slide the switch to OFF NC LED indicator off...
Page 11
Connect an Additional Bluetooth Devices 1. Make sure the headphones are connected to the first Bluetooth device successfully and music is not playing. 2. Hold the Multi-function Button until the headphones re-enter pairing mode (the indicator light will flash red and blue alternately). 3.
Page 12
Charge the headphones Blinking red (LED indicator) with a voice prompt “du-du” Low battery Flashing red and blue for 1 second Low battery shutdown Solid red (LED indicator) Charging Off (LED indicator) Fully charged...
Page 13
Q&A Q: Failed to connect devices with headphones? A: Please ensure your headphones in pairing mode. Then delete the pairing record on the Bluetooth devices and reconnect with headphones. Q: Failed to turn on the headphones? A: Please check the battery status of your headphones. Q: Can I replace the battery in the headphones? A: No.
Page 14
A: The configurations of various application softwares are different, the headphones may not be completely compatible with some APPs. Q: What should I do if the Bluetooth connecting function cannot close or open? A: Please reset the Bluetooth function of the headphones by inserting an audio cable into the audio port and removing it.
Page 15
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Safety Instructions 1. Read, follow and keep these instructions. 2. For the best possible experience, always use the product as described by the manufacturer. 3. Always handle your headphones with care and protect them from external damage. 4. Clean your headphones using a soft dry cloth. Never use water, cleaning detergent, leather polish or other substances as they may damage your headphones permanently.
Page 17
15. Do not expose the headphones to temperatures below -20°C or above +45°C. 16. Do not charge the headphones in temperatures below 0°C or above +45°C. 17. Do not attempt to burn the headphones. The battery could explode causing injury and death. 18.