Advertisement
6. MAINTENANCE
‰ ‰ WARNING! With the exceptions listed below, all pump, float and electrical cable service maintenance and repair must only be
‰
‰
undertaken by an authorised service agent. Failure to observe this rule may be dangerous and will invalidate the warranty.
‰ ‰ WARNING! Ensure the pump is disconnected from the mains power supply before attempting any service or maintenance.
‰
‰
6.1.
Keep all parts of the pump clean. Rinse, drain and allow to dry before storing the pump.
6.2.
Regularly check the inlet filter in the base of the pump to ensure that there are no blockages. To access push and turn the circular door
anticlockwise. Remove the circular foam filter element and wash in warm water. Replace the filter and refit the door.
DO NOT dismantle any other part of the unit.
8
7. TROUBLESHOOTING
Problem
Motor operates but there is no suction.
Reduced water volume for level of
water.
Pump will not start or suddenly stops
during operation.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Cause
1. Water level below min. suction depth.
2. Air bubbles in pump accumulated during
submersion, or float incorrectly positioned so
pump does not stop at minimum level and sucks
in air.
3. Clogged intake filter or discharge pipe.
1. Flow control closed too far.
2. Discharge pipe too narrow.
3. Filter partially blocked.
1. No electrical power.
2. Float not working.
Dispose of this product at the end of its working life in compliance with the EU Directive on
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
Original Language Version
Remedy
1. Stop the pump.
2. Release air by inclining the pump and
re-immersing it in water.
3. Remove blockage and clean the unit.
1. Open flow control.
2. Use wider diameter pipe.
3. Clean filter.
1. Check cable, plug and fuse.
2.Contact authorised service agent.
Environmental Protection
WEEE Regulations
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
WPB50A.V2| Issue 1 05/04/16
Advertisement
