Advertisement
5. OPERATION
i
5.1.
Remove either the upper or lower paper bar from the frame by unscrewing and removing the black knobs at either end.
5.2.
Loosen the screw in one of the black plastic retaining rings and remove the ring, spring and washer from the end of the bar.
Remove the cardboard tube centre of the last roll from the bar.
5.3.
Slide the the paper bar through the centre of the new paper roll and refit the washer, spring and retainer to the end of the bar.
Temporarily tighten the screw in the black retaining ring.
5.4.
To refit the loaded bar to the frame get a second person or persons to support the paper roll while the black knobs are fitted at either end
of the bar. The paper should be coming off the top of the roll. Once loaded, check that the roll is centrally placed on the paper bar and
make any necessary adjustments using the black retaining rings.
5.5.
Push a roll of masking tape onto each tape dispensing reel and spin it to make sure the tape is running true. Check that the tape
dispensers are aligned with the ends of of the paper roll as shown in fig.3.
(The centre line of the tape should align with the edges of the paper roll). The position of the tape dispensers can also be adjusted as
shown in fig.2. To increase or decrease dimension 'X' loosen the wing nut 'Z' and roll nut 'Y' up or down the bolt as required. Re-tighten
the wing nut.
5.6.
Pull about 18" of paper from the roll and feed it between the paper spring and the back edge of the adjacent paper cutter.
5.7.
Pull tape from each dispenser in turn and stick it to the paper roll so that it is half on and half off the paper edges. Check the alignment of
the tapes and make any further adjustments required to the positions of the tape dispensers.
5.8.
Slowly pull the paper from the roll and check that the tapes feed correctly onto the edges of the paper.
5.9.
Tear the paper off with an upward movement against the down facing teeth of the paper blade. Keep hands well away from the blade
when doing this.
5.10.
Load the other paper bar as described above.
NOTE: A fully loaded frame is quite heavy. Take care when moving it and always leave it in a stable position.
.
fig.2
fig.3
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice .Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.4
www.sealey.co.uk
MK67.V2 | Issue:2 (H,F) 06/03/20
Advertisement
