Installation - Glacier bay HD67083W-6010H Installation And Care Manual

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Ensure the gasket (B) is on the bottom of the
new faucet (A).
□
Place the faucet (A) through the mounting
holes in the sink.
□
Secure the faucet (A) to the sink using the
mounting nuts (C) provided. Hand-tighten only.
NOTE: Silicone sealant is required under the gasket (B).
2
A
B
C
4
Preparing the pop-up assembly
□
Remove the bottom gasket (F) and nut (G) from
the top gasket (D) and pop-up body (E).
□
Attach these pieces together by pushing the
bottom gasket (F) down into the top of the
nut (G) and twisting together.
D
E
F
G