Advertisement
9.2.2.2.
Carefully hold and pull the cartridge filter up and remove.
(fig.6.3).
9.2.2.3.
Clean the cartridge filter by gently tapping or brushing dirt off.
(fig.6.4).
9.2.2.4.
Cleaning should not be performed in indoors, in living areas.
For optimal performance a new filter is recommended.
9.2.2.5.
Install cleaned or new filter as above.
9.2.2.6.
Wet filters should be removed and allowed to air dry for 24
hours before installing onto the filter cage.
9.2.3.
FOAM FILTER MAINTENANCE
9.2.4.
Installing foam sleeve filter
9.2.4.1.
Remove power head and place in upside down position.
Follow instructions to remove cartridge filter.
9.2.4.2.
Carefully slide foam sleeve filter down over the filter cage
making sure the whole cage is covered. (fig.7.1, 7.2).
9.2.5.
Cleaning foam sleeve filter
9.2.5.1.
With the removed power head in the upside down position,
carefully remove the foam sleeve filter. (fig.7.3).
9.2.5.2.
Use a mild soap and water solution to wash the foam sleeve
filter and rinse with clean water. (fig.7.4).
9.2.5.3.
Allow filter to air dry before installing and using again.
10. TROUBLESHOOTING
Cleaner will not operate
Dust comes from the motor cover
Reduced efficiency and increased
motor speed/vibration
IMPORTANT! IF THE MACHINE IS USED WITHOUT A FILTER THIS MAY CAUSE DAMAGE TO THE MOTOR AND THE GUARANTEE
WILL BE INVALIDATED. ALWAYS KEEP A SPARE FILTER HANDY.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
No power supply
Faulty power cable
Container full of liquid
Cartridge filter missing or damaged
Container full
Filter clogged
Nozzle, hose or container inlet blocked
01284 703534
Original Language Version
fig.6
fig.7
Check power supply
Check and repair or replace faulty item
Empty container
Fit or replace cartridge filter
sales@sealey.co.uk
www.sealey.co.uk
PC200.V3 Issue:3 (H,F) 26/06/20
Advertisement
