Philips Norelco Bodygroom 3000 Series Manual page 4

an attachment plug adapter of the proper
configuration for the power outlet.
Operating time
When the product is fully charged, it has a
cordless running time of up to 50 minutes.
Using the product
You can use the product wet or dry to shave
or trim hair on all parts of the body below
the neckline (Fig. 5Fig. 6).
Always check the product and all
accessories before you use it. Do not use
the product or any accessory if it is
damaged, as this may cause injury. Always
replace a damaged part with one of the
original type.
- Use this product for its intended
household use as described in this manual.
- For hygienic reasons, the product should
only be used by one person.
- Trimming is easier when the skin and hair
are dry
Note: This product is waterproof. It is
suitable for use in the bath or shower and
for cleaning under the tap. For safety
reasons, this product can therefore only be
used without cord (Fig. 7).
Switching the product on and off
1 Press the on/off button once to switch
the product on or off (Fig. 8).
Attaching and detaching guards
1 To attach a guard, snap the front part of
the guard onto the teeth and push the
projection at the back of the guard into
the product ('click') (Fig. 9).
2 To detach a guard, carefully pull the back
part off the product and then click it off
the cutting element (Fig. 10).
Trimming length setting
The trimming guard allows you to cut hair to
a length of 3mm/ 1/8in.
Trimming
- If you are trimming for the first time, be
careful. Do not move the product too
fast. Make smooth and gentle
movements.
- Since all hairs do not grow in the same
direction, you may want to try different
trimming positions (i.e. upwards,
downwards, or across). Practice is best
for optimum results.
- Always make smooth and gentle
movements and be sure the surface of
the guard always stays in contact with
your skin.
- For body trimming, make sure hair is
clean and dry as wet hair tends to stick
to the body and when trimming sensitive
areas, always use a trimming guard.
Trimming
1 Snap the desired trimming guard onto
the product (Fig. 9).
2 Press the on/off button to turn on the
product.
3 Trim against the hair grain for optimal
performance (Fig. 11Fig. 12).
Note: Make sure that the flat part of the
trimming guard is always fully in contact
with the skin.
4 Turn off and clean the product after each
use (see 'Cleaning').
Shaving
Do not use this shaving unit to shave or
trim facial or scalp hair.
- When shaving sensitive areas for the first
time, you may feel some discomfort,
irritation or reddening of the skin. This is
normal as your skin needs time to adjust
to shaving.
- If your hair is longer than 13/32in. (10
mm), trim hair to a length of 1/8in. (3mm)
first for optimum shaving results.
- For dry use, be certain that your skin is
clean and dry before using the shaving
unit.
- For wet use, prepare your skin with
lathered soap or shaving foam before
using the shaving unit.
1 Remove any trimming guard from the
product.