Perlegear PGSS7 Instruction Manual

STEP 5 Route the cables
IMPORTANT SAFETY INFORMATION
• Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
• Please carefully read all instructions before attempting installation. If you do
not understand the instructions or have any concerns or questions, please
contact our customer service at support@perlegear.com.
• Before starting assembly, verify all parts are included and undamaged. Do not
use damaged or defective parts. lf you require replacement parts, please
contact our customer service at support@perlegear.com.
• Please note: Not all hardware included in this package will be used.
• This product may contain moving parts. Use with caution.
• Do not use this product for any purpose that is not explicitly specified in this
manual. Do not exceed weight capacity. We are not liable for damage or injury
caused by improper mounting, incorrect assembly or inappropriate use.
Tools Needed (Not lncluded)
Philips Screwdriver
Supplied Parts
Base 01
x2
04
90 Degree Plate x2 Square Plate
Supplied Hardware
Nail Nut Pad Sponge
A B C D
x6 x6 x6 x2
- 7 -
Post Extension 02
x2
03
Post Assembly x2
05
x2 Narrow Plate
Bolt
Plastic Nut
1/4" x13.5mm #6 x #14
E F
x2 x2
- 1 -
Thank you for choosing this Perlegear product! At Perlegear we strive to
provide you with the best quality products and services in the industry.
Should you have any issues, please don't hesitate to contact us at
support@perlegear.com(US/CA)
Bolt
M5x8mm
G
x2
Bolt
M6x12mm
L
x4
STEP 1 Attach the nails or rubber pads to the base feet
For carpets floor, screw the nails
into the holes of the base.
OPT
A
06
x2
For marble or wooden floor, rotate
and insert the rubber pads into the
holes of the base.
Washer
B
OPT
B
P
x4
Speaker Floor Stand
Instruction Manual
Model: PGSS7
Bolt Bolt
M5X12mm 1/4"x12mm M4X12mm
H I
x4 x4
Bolt Nut
#6-32 x 1 1/4" #6-32
M N
x2 x2
A
B
C
- 2 -
V2.0
Bolt Washer
M4/M5
J K
x4 x4
Washer
#6
O
x2
01
01