Computime Salus Controls TS600 User Manual

Temperature sensor/thermostat
Model: TS600
User manual
PRODUCER:
Salus Limited
6/F, Building 20E, Phase 3, Hong Kong Science
Park, 20 Science Park East Avenue, Shatin,
New Territories, Hong Kong
IMPORTER:
QL CONTROLS Sp. z o.o. Sp. k.
ul. Rolna 4, 43-262 Kobielice
www.salus-controls.eu
SALUS Controls is a member of the Computime Group.
Maintaining a policy of continuous product development SALUS
Controls plc reserve the right to change specification, design and
materials of products listed in this brochure without prior notice.
Introduction
TS600 is a surface-mounted sensor and a thermostat for wireless
control of SALUS Smart Home devices. Installation and configuration
are carried out using the SALUS Smart Home application, the UGE600
universal gateway is also required for operation. In Online mode it can
communicate with devices such as: KL08RF wiring centre, mini TRV
radiator head, RX10RF receiver, SR600 smart relay and SPE600 smart
plug.
SALUS Smart Home
GET IT ON
Product compliance
This product complies with the essential requirements and other
relevant provisions of Directives 2014/53/EU and 2011/65/EU. The full
text of the EU Declaration of Conformity is available at the following
internet address: www.saluslegal.com.
2405-2480MHz; <14dBm
Safety information
Use in accordance with the regulations. Indoor use only. Keep your
device completely dry. Disconnect your device before cleaning it with
a dry cloth. This accessory must be fitted by a competent person,
and installation must comply with the guidance, standards and
regulations applicable to the city, country or state where the product
is installed. Failure to comply with the relevant standards could lead
to prosecution.
Box content
1 2
TS600 thermostat Mounting plate
4 5
Short instruction Mounting screws
Connection description
Download on the
Mounting and installation of the thermostat
Mounting: to mount thermostat you can use accesories included with
the set (mounting screws). Remove back cover to mount the plate to
the wall. Now please insert the batteries inside the thermostat. After
this just attach thermostat to the plate right into designed holes in
the plate.
1
An external sensor can be
connected to the S1 and
S2 terminals. Purchased
3
3
2 x AA batteries
Insert the batteries.
TS600 will automatically
go into pairing mode.
S
TS600
S2
3V
2 x AA
S1
2
Mount the back case on
the wall.
separately.
4
Add the front case.