hotspot energy ACDC12C Service Manual

hotspot energy ACDC12C Service Manual

Solar air conditioner

Advertisement

HotSpot Energy Inc.
Solar Air Conditioner Service
Manual
ACDC12C / ACDC18C
Indoor Units:
ACDC12C-IDU
ACDC18C-IDU
Outdoor Units:
ACDC12C-ODU
ACDC18C-ODU
Version 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACDC12C and is the answer not in the manual?

Questions and answers

Robert mills
June 9, 2025

Is cn6 a 10k thermister

Subscribe to Our Youtube Channel

Summary of Contents for hotspot energy ACDC12C

  • Page 1 HotSpot Energy Inc. Solar Air Conditioner Service Manual ACDC12C / ACDC18C Indoor Units: ACDC12C-IDU ACDC18C-IDU Outdoor Units: ACDC12C-ODU ACDC18C-ODU Version 3...
  • Page 2: Table Of Contents

    Table of Contents Installer Warnings ……........................1 Safety Precautions ……………………………………………………………………………..……………………….……….2 Specifications …..………………………………………………….………………………………….………………….…..……3 2.1. Unit Specifications ……………………………………………………….………………………………………3 2.2. Operation Characteristic Curve…………………………………………………………………….………5 2.3. Capacity Variation Ratio According to Temperature…………………………………………..5 2.4. Operation Data ……………………………………………………………………………..……….……..6 2.5. Noise Criteria Curve Tables for both Models……………………………….……….………………6 Construction Views …………………………………………………………………………………………..……..…………7 3.1.
  • Page 3: Installer Warnings

    WARNING: The unit does not export power, it cannot send power to the grid, there is no “output” and it does not need a grid interactive connection for the solar assist. WARNING: The rated DC voltage of 380 is the “voc” rating, the ACDC12c uses the “vmp” rating which is 300 vdc max.
  • Page 5: Specifications

    ACDC12C Specifications...
  • Page 6 ACDC18C Specifications...
  • Page 23: Display Status

    Display Status...
  • Page 24: Installation Manual

    All solar with Grid available. 7. Installation Manual 7.1 Notices for Installation Caution 1. The unit should be installed only by authorized service center according to local or government regulations and in compliance with the manual. 2. Before installing, please contact with local authorized maintenance center, if the unit is not installed by the authorized service center, the malfunction may not be solved die to inconvenient contact between the user and the service personnel.
  • Page 25  High-frequency electro-magnetic waves are generated by radio equipment, welders and medical equipment.  Salt-laden air prevails (such as close to coastal areas).  The air is contaminated with industrial vapors and oils.  The air contains Sulphur’s gas such as in hot spring zones. ...
  • Page 26 7.1.4 Safety Precaution for Electric Appliances 1. A dedicated power supply circuit should be used in accordance with local electrical safety regulations. 2. Don’t drag the power cord with excessive force. 3. The unit should be reliably earthed and connected to an exclusive earth device by the professionals.
  • Page 28: Install Indoor Unit

    7.3 Install Indoor Unit 7.3.1 Installation of Mounting Plate 1. The mounting plate should be installed horizontally with a very slight tilt towards the drain hose. The condensation trays drain outlet can be either on the right or the left. 2.
  • Page 29 7.3.2 Drilling Piping Hole 1. Slant the piping hole slightly downward to the outdoor side. 2. Insert the piping sleeve into the hole from the inside to prevent the line-set and cabling from getting damaged when passing through the hole. 7.3.3 Installation of Drain Hose 1.
  • Page 30: Install Outdoor Unit

    2. Screw in the flair nut by hand and then tighten the nut with a spanner and torque wrench by referring to the following. Pipe Size Torque Model 6.35mm (1/4”) 13.27 ft. lbs ACDC12c&18C 9.52mm (3/8”) 30.97 ft. lbs ACDC12C 15.88mm (5/8”) 40.56 ft. lbs ACDC18C Additional Freon if more than 5m ACDC12C 20 g/m ACDC18c 30 g/m...
  • Page 31: Install Pv-Module

    You will need at least one of these adaptors to service the unit. 7.4.2 Air Purging and Leak Test 1. Connect the blue hose from the manifold gauges to the service port on the ODU. 2. Connect the yellow hose to a vacuum pump, do not open valves at this time. 3.
  • Page 32 7.5.2 Mechanical installation 1. Mechanical installation should be carried out by a professional solar photovoltaic installer. 2. If you purchased the panels and roof racking form HotSpot you should have the installation manuals, if not please contact our technical support department for the latest versions. 757-410-8640 x112 7.5.3 Electrical Installation 1.

This manual is also suitable for:

Acdc18cAcdc12c-iduAcdc18c-iduAcdc12c-oduAcdc18c-odu

Table of Contents