SPLITTY SPY-FLR Assembly Instructions

Splitty
floor lamp
Assembly Instructions
LED head Power Supply
1
Upper Body
Lower Body
5
Plug transformer into the cord on the lower body
Limited Product Warranty
Koncept warrants to the original purchaser of this product against manufacturer defects in design, assembly, material, or workmanship, and will, at Koncept's
option, replace or repair any defective product free of charge. This coverage is valid for five years from the date of purchase as long as the original purchaser owns
the product. In the case of a hardwired product, this warranty is valid for one year for the LED driver specifically. Koncept will replace or repair the product, which
Koncept, at its sole discretion, agrees is defective, free of charge provided that the following conditions for a return are fulfilled.
This warranty does not apply to any product damaged by accident, physical or electrical misuse or abuse, improper installation, alteration, any use contrary to its
intended function, war, fire, flood, or any other acts of nature, or unauthorized repair. This warranty does not apply to the LED driver in the case of a hardwired
product. A one year warranty applies to all hardwire drivers, while the five year warranty applies to the actual product.
Koncept assumes no liability for any events such as fines arising out of the use of this product or any consequential damages caused by any failure of the product to
function properly. In no event shall Koncept be liable for more than the replacement of the product. This warranty does not cover shipping or labor costs associated
with the replacement of a defective product. Under no circumstances should this warranty or the product covered by it be construed as an insurance policy against
loss of any kind. Koncept staff neither assumes nor authorizes any person or organization to make any warranties or assume any liability in connection with the sale
or use of this product.
This warranty covers only products used in the territory covered by your local distributor. This is the complete product warranty and no other warranty exists. Some
jurisdictions may not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so the above
exclusions or limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary in different states and
countries.
To file a replacement/repair claim under the warranty:
1) Contact Koncept for a return authorization number during the warranty period. A claim will not be accepted without a return authorization number.
2) Provide a copy of the original purchase receipt with purchase date and product name clearly shown.
3) Return the defective product to Koncept, freight prepaid, accompanied by (1) and (2) to the following address: Limited Product Warranty, Koncept Inc. 429 E.
Huntington Drive, Monrovia, CA 91016
2
Push down the lamp body to the base and click into place.
With the provided hex wrench, secure the lower body to the base.
6
Touch the button to turn on & off, hold it to dim /
brighten the light.
3
Connect the upper body to the lower body and push into place.
7
Charge your USB device with the built-in USB port.
Warnings
To reduce the risk of fire, electric shock or injury:
• Do not use near water
• Do not handle plug or appliance with wet hands
• Do not stare directly at LEDs
Overheating may result in reduced LED lifespan:
• Keep out of direct sunlight.
• Remove plastic bag from lamp before use.
• Recommended ambient temperature: under 77 °F.
Koncept Inc.
429 E. Huntington Drive
Monrovia, CA 91016, USA
Phone: 323-261-8999
Fax: 323-261-8998
Customer Support:
support@koncept.com
www.koncept.com
4
Push LED head into the lamp body.
8
Splitty floor lamp features a 9 hour auto shut-off
feature. This is enabled by default.
To enable/disable the auto shut-off:
press and hold the dimmer button for 10 seconds. The
light flashes 3 times to indicate that the feature is
enabled. The light flashes 1 time to indicate that the
feature is disabled.
Specifications
Model SPY-FLR
Light Color
Color Temperature 3500 K
Brightness Adjustability
USB rating
Register your Koncept LED lamp online and receive:
• One Year Warranty Extension
• Priority Product Servicing
Visit www.koncept.com/productsupport and enter your
serial number (S/N: XXXXXXXX) located on your product.
Warm White
Continuous
5V 1A
v. 06182020