SPC Multicomp HU2772 Instruction Manual

USB2.0 HUB
7 Port

Safety Instructions:

Always read the safety instructions carefully:
• Keep this User's Manual for future reference.
• Keep this equipment away from humidity
• If any of the following situation arises, get the equipment checked by a service technician:
1. The equipment has been exposed to moisture.
2. The equipment has been dropped and damaged.
3. The equipment has obvious sign of breakage.
4. The equipment has not been working well or you cannot get it work according to user's manual.

Copyright Statement:

No part of this publication may be reproduced in any form by any means without the prior written permission. Other trademarks or
brand names mentioned herein are trademarks or registered trademarks of their respective companies.

Disclaimer:

Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties
(implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for any loss of profit
or any commercial damage, including but not limited to special, incidental, consequential, or other damage.

Installation Verification:

• After you connect this hub to PC by a USB cable, the system will detect the device and install the required drivers automatically.
• After installation finished, you can go to Device Manager to verify the completed installation*.
*According to previous description, the driver is based on host system. The following image is based on USB 1.1 hub installed. The
device name may be varied on your host.
http://www.farnell.com
http://www.newark.com
http://www.cpc.co.uk

Features:

• Compatible universal serial bus specification revision 2.0 (data
rate 1.5/12/480Mbps).
• Connects up to 127 USB devices.
• Bus-power and self-power mode used.
• Plug-and-play function.
• 1 upstream and 2/4/7 downstream USB ports included.
• Over-current detection and protection.
Page <1> 21/11/09 V1.1