Oster OAP706 Instruction Manual page 13

TO OPERATE YOUR AIR PURIFIER
1. Plug into the appropriate electrical outlet.
2. Select the operating speed of HIGH (
the speed control knob to the appropriate setting.
3. To release negative ions into the filtered air, turn the Ionizer (
ON and the light will illuminate.
4. The lonizer will not work unless Air Purifier is running.
5. For optimum air filtration, it is recommended to operate the Air Purifier continuously.
Its rugged motor has been designed to give many years of use.
TO REPLACE YOUR FILTER
1. Turn off and unplug the air purifier.
2. Open the air inlet grill and examine the black foam prefilter. Remove any dust or lint
and wash in warm soapy water. Rinse, air dry and place back into grill inlet.
3. Remove the used Aer1
discard it. DO NOT attempt to clean the Aer1
4. Install the new Aer1
that the hang tab is securely in place. The clip(s) can only be attached to the tabs on
the filter(s) one way. The filter clip(s) should easily slide onto the filter hang tab with
only a small amount of pressure. DO NOT use force while attaching the clip to the
filter. (Fig. 2)
5. Align the clip(s) on the side of Aer1
unit. Gently slide the filter(s) onto the rail.
6. Replace air inlet grill.
), MEDIUM (
filter(s) from the unit by pulling it gently towards you and
®
filter(s) into the unit. Before replacing the filter(s), make sure
®
filter(s) with rails on the inside of the purifier
®
Fig. 2
English - 5
) or LOW (
) Control Knob to
filters.
®
) by turning