Advertisement
5. INSTRUCTIONS
IMPORTANT: These instructions are provided as a guide only. Always refer to the vehicle manufacturer's service instructions, or a
proprietary manual, to establish the current procedure and data.
IMPORTANT: Force screw maximum load is 150Nm. Exceeding this load will shorten the life of the force screw. The force screw
is considered to be a consumable item and is NOT covered under warranty.
IMPORTANT: Always keep force screw well lubricated.
Preparation.
With the vehicle properly supported and accessible, remove the rear wheels. Making reference to the vehicle manufacturer's service
instructions remove the swinging arm assembly and the bolts which pass through the ball joints.
5.1.
Removing the old ball joint. (fig.3)
5.1.1.
Using the component configuration indicated below in fig.3, assemble the parts to the ball joint housing. (See also fig.1).
5.1.2.
Ensure that the flat head of the force screw (1) is fully inserted into the slot in the face of the driver component (3).
5.1.3.
Also ensure that the driving face of the force nut (2) bears onto the bearing mounted in the receiver component (4).
5.1.4.
Remove snap retaining ring from the ball joint.
5.1.5.
Note: The driving component (3) must be placed to drive the ball joint out towards the front of the vehicle.
5.2.
Installing a new ball joint. (fig.4)
Prior to installing the new ball joint ensure that the ball joint housing is clean.
5.2.1.
Using the component configuration indicated above in fig.4, assemble the parts to the ball joint housing.
5.2.2.
Ensure that the flat head of the force screw (1) is fully inserted into the slot in the face of the installation anchor component (6).
5.2.3.
Also ensure that the driving face of the force nut (2) bears onto the bearing mounted in the installation driver component (5).
5.2.4.
Note: The installation driver component (5) must be positioned to drive the new ball joint into place towards the back of the vehicle.
5.2.5.
Reinstall the snap retaining ring and re-assemble the vehicle suspension in accordance with procedures laid down in the manufacturer's
service manual.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.3
01284 703534
sales@sealey.co.uk
Original Language Version
fig.4
www.sealey.co.uk
VSE5509.V2
Issue 2 (H,3,F) 23/03/18
Advertisement
