GRAPHTEC F-MARK2 Quick Start Manual

Automatic sheet feeder

Hide thumbs

Simplified Basic Operation Workflow

Key Functions & Simpli ed Operation For Smooth Work ow

This quick guide works best when the following has been completed:

• Basic installation of the F-MARK2 unit as outlined in the User's Manual instructions

• Installation of the latest version of iMark Plus Software available for downloading at:

www.graphtecamerica.com/software

The User's Manual for the machine & software will guide you through the complete process.

Please note that the Setup User's Manual also covers a Troubleshooting Section, so in the

event you run into issues, please refer to the manual before contacting Technical Support.

Graphtec also provides helpful Video Training Videos for the F-MARK2 on our website.

Click on the QR Code below or view the tutorials at

www.graphtecamerica.com/videos

F-MARK2

Table of Contents

Need help?

Do you have a question about the F-MARK2 and is the answer not in the manual?

Questions and answers

Summary of Contents for GRAPHTEC F-MARK2

Page 1 Key Functions & Simpli ed Operation For Smooth Work ow This quick guide works best when the following has been completed: • Basic installation of the F-MARK2 unit as outlined in the User’s Manual instructions • Installation of the latest version of iMark Plus Software available for downloading at: www.graphtecamerica.com/software...
Page 2 C - Designing Templates for the F-MARK2 D - iMark Software Overview A - Calibrating the CCD Camera White Point using Provided Black Media Chapter 16: How to Calibrate the F-MARK2 ( Starting on page 37) • Launch the iMark Software •...
Page 3 ( If the values are di erent, repeat calibration. Also, make sure you have su cient lighting ) NOTE: Camera calibration will need to be performed every time changes occur. When the computer is shut o , when the F-MARK2 is disconnected from the USB port or if the software stops communicating.
Page 4 SIMPLIFIED BASIC OPERATION WORKFLOW The User’s Manual suggests using the provided X- Y Calibration Sheet for adjustments. To increase accuracy, it also suggests using the current job to perform the calibration • Turn on the Power for the CE7000 Cutter. - Open iMark software, - Feed a printed job into the cutter and align it with the rst registration mark.
Page 5 SIMPLIFIED BASIC OPERATION WORKFLOW C - Designing Templates for the F-MARK2 Design Orientation must be Landscape for 11”x17” - 12”x18” - 13”x19” Design Orientation must be Portrait for 8.5“x11” - 8.5”x14” Leading Edge and Feeding Direction is always RIGHT to LEFT...
Page 6 SIMPLIFIED BASIC OPERATION WORKFLOW D - iMark Software Overview To make things easier, the iMark Software panel is broken down into di erent sections for each function. See Pg. 1 of Software User’s Manual Current camera view Last camera shot Calibration commands Common commands area Preview area...