Philips SDV3427W/27 User Manual page 15

If you are using a pre-built cable that has connec-
tors, follow these steps.
i. Cut 4 slits spaced evenly apart at the narrow tip
of the provided Rubber Boot approximately 1/4"
in length. (Fig. 6c)
ii. Run the cable through the narrow end of the
Rubber Boot and attach the cable to the Cable
Fixing Accessory on the Reflector.
iii. Slide the Rubber Boot into the round channel
on the Main Housing Unit.
iv. Using the Small Zip Tie, wrap the tie around
the narrow tip of the Rubber Boot, around the
four slits and pull the tie tight.
Use a second coax cable and connect one end to
the mating port of the first coax cable on the 75
ohm grounding block and run the other end into
your home for making the connection to your TV.
The 75 ohm grounding block needs to be placed
as close as possible to the point where the second
coax cable enters your home.
Note: Leave enough slack in the coax cable to
create a drip loop so that moisture cannot enter
the house. You will also need to seal the coax cable
entry point into your house with an exterior caulk.
Fig. 6c
15