Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for LSK FuelGaugePro
- Page 1 FuelGaugePro Bar Graph Display Panel FGP-DIG-SEG | INSTALLATION MANUAL...
-
Page 2: Table Of Contents
Table of Contents Basic information Technical specification Installation Installation of display panel Connecting the display panel Settings diagram Calibration Calibration type choice Simple low/high fuel level calibration Calibration with fuel tank shape compensation How the gauge displays the calibrated data Bottom segment flashing on empty tank Factory reset Warranty... -
Page 3: Basic Information
Basic information The FuelGaugePro – Bar Graph Display Panel is a display panel designed for displaying actual amount of fuel in fuel tank in cooperation with FuelGaugePro - Float-free Fuel Level Sensor. It is mountable on double-sided adhesive tape on the dashboard of motorcycles, cars, boats etc. For best visibility on the direct sunlight and not blinding at night, the display panel have automatic brightness regulation. -
Page 4: Installation
Clean the surface with alcohol for the best adhesion of the 3M adhesive tape. b) Stick the Display Panel on desired place using included 3M adhesive tape. 2. Connect the FuelGaugePro – Bar Graph Display Panel together with the FuelGaugePro – Sensor using original connector. -
Page 5: Settings Diagram
Settings diagram Display Panel is equipped with non-contact magnetic switch. Whole settings and calibration process are performed by proximity the magnet near the place shown on picture. -
Page 6: Calibration
What you must think on during calibration: - Make sure the FuelGaugePro – Float-free Fuel Level Sensor, the fuel tank and all parts of fuel system are on its final places and bike stands in its riding position (not on kickstand). -
Page 7: Simple Low/High Fuel Level Calibration
2. Simple low/high fuel level calibration a) Low level set: - Ride the gas out to the amount you want to gauge show as a minimum. You can use the moment when you switch to reserve for example. - Make sure the petcock is opened and bike stands straight. - Hold the included magnet in active area of Display Panel as you see on picture on page 2 for 3-5 seconds. -
Page 8: Calibration With Fuel Tank Shape Compensation
Device is prepared for storing third value (20%). - Repeat previous step for two flashing bottom segments (20%), three bottom flashing segments (30%) up to ten flashing segments (100% of fuel tank capacity). - Now the FuelGaugePro system is calibrated. -
Page 10: Bottom Segment Flashing On Empty Tank
Bottom segment flashing on empty tank Using this settings toggles between on and off. Flashing off means no segment is illuminated when the Display Panel shows empty tank. Flashing on means first segment is flashing when the Display Panel shows empty tank (factory setting). - Hold the included magnet in active area of Display Panel as you see on picture on page 2 for 3-5 seconds. -
Page 11: Warranty
Warranty Product is covered by 2 years Limited Warranty (from the date of purchase). Limited Warranty covers any defects in material or manufacturing defects under normal use and maintenance. We reserve the right not to accept the claim in the case of mechanical damage that could be related to the defect of the product or if the product was disassembled by unauthorized service. -
Page 12: Recycling
Recycling Retired device should be given to places specified for retrieving electrical garbage. Package should be thrown into a specific container for recycled garbage. Device meets RoHS Directive. www.lskelectronics.com info@lskelectronics.com Product website:...
Need help?
Do you have a question about the FuelGaugePro and is the answer not in the manual?
Questions and answers