Table of Contents
Advertisement
Available languages
Available languages
USA
Switching ON/OFF/selecting a level
Switching ON/OFF/selecting a level
− If the temperature is too high due to a blocked air inlet or outlet
opening, the brush will automatically switch itself OFF.
You must wait until the brush has cooled down before
switching it ON again.
− Make sure the brush attachment is securely fitted before
switching ON the brush.
− For optimal results, shampoo and condition your hair prior to
using the brush.
− When the brush is switched ON, the IONIC indicator light
be illuminated.
1. Connect the ALCI plug
2. Slide the level switch
Slide to position "2" for a high air-flow with heat.
Slide to position "1" for a reduced air-flow with heat.
Slide to position "0" to switch the brush OFF.
Using the brush attachment
The brush comes with a large round brush, a small round brush and a half brush.
The brush attachment may become very hot when in use. Only
touch the handle
Attaching the brush attachment
1. Insert the desired brush (
(see step 1 in fig. B). Make sure the slots on the brush have been fitted onto
the tabs on the handle.
2. Slightly twist the brush to the left until you hear it click into place
(see step 2 in fig. B).
You have successfully fitted the brush.
Detaching the brush attachment
1. Press the release button
2. Slightly twist the brush to the right. Pull the brush out from the handle
(see step 2 in fig. C).
You have successfully removed the brush.
14
service@801service.net
6
to a wall outlet.
4
to a desired position.
9
during operation.
1
/
10
/
11
) into the top of the handle
2
on the side of the handle (see step 1 in fig. C).
Volumizing Hot Air Brush
5
9
AFTER SALES SUPPORT
1 866 588 8096
USA
will
Advertisement
Chapters
Table of Contents
