Advertisement
Quick Links
Installation A: With an alarm
Illuminates when alarm is Armed. Turns off when Disarmed.
For addition help, please consult your alarm system's manual.
Installation B: Without an alarm
INSTALL "B" REQUIRES PURCHASE OF THE OPTIONAL GAP-2
If you install to IGN without the GAP-2, engine noise could damage the LED over time.
GAP-2
(Retail: ¥1,600)
NOTE: DO NOT use the instructions in this box if you want the LM400+ to work with an alarm!
WARNING!
To prevent a fire or
malfunction due to a
short, be sure to
cover the unused
connector with the
included rubber cap.
IMPORTANT!
DO NOT illuminate product
while driving.
The Ultimate in Car Security
®
BLK Connect to the (–) car battery terminal or the metal
body of the car itself.
YEL
Connect to the alarm's (–) Ground-When-Armed output.
RED Connect to constant (+)12v.
RED
BLK
GRN/WHT
YEL
YEL
RED
BLK
16 Selectable Scanning Patterns
To change patterns, press product button while Ignition is ON.
3 Selectable Speeds
To change speeds, press product button while Ignition is OFF.
NOTE1: Pattern will change with each button press.
NOTE2: Flash memory saves your selection when power is cut.
LM400+
To (+)12v power.
To (–) Ground.
To Ignition, ACC or car stereo fuse.
(Must be (–) GND when engine is off.)
To (+)12v power.
To (–) Ground.
CONSUMPTION
www.kiramek.com
SERIES
5mA (avg.)
Advertisement
