InCarTec 29-UC050-REN1 Quick Start Manual

29-UC050-REN1
RENAULT ISO Canbus
STEERING CONTROL INTERFACE
Clio 2006-2008
Clio 2009->
Koleos 2008-2010
Laguna 2006-2007
Laguna III 2008->
Megane 2006-2007
Megane III 2008->
Modus 2006->
Traffic* 2008->
Twingo 2009->
14 Pin connector on interface box as
seen from wire entry side.
1 2
8 9
Use this interface along with a head unit specific patch lead, pins 4, 8 and 12 terminate at
a 4 Pin connector, this is where you will need to connect the head unit patch lead.
When connected the CANbus interface will automatically recognise the vehicle. The
green LED on the interface will repeatedly flash once followed by a pause.
You will need to set the interface to the make of head unit you are fitting.
The amount of flashes between pauses corresponds to the make of head unit, see the
table overleaf for the number of flashes and which make it corresponds to.
While the LED is flashing green, press the Vol +/- buttons on the cars steering wheel to
change the amount of flashes between pauses, Vol + will increase the amount of flashes,
Vol– will decrease the amount of flashes.
When you have the correct amount of flashes, press seek+ to confirm and the LED will go
to a solid green light.
√ X X
√ √ √
√ √ √
√ X X
√ √ √
√ X X
√ √ √
√ X X
√ X X
√ √ √
3 4 5 6
10 11 12 13
X X X
√ √ √
√ √ √
X X X
√ √ √
X X X
√ √ √
X X X
X X X
√ √ √
1 Yellow/Whtie
2 Green
3 Orange
4 Brown
5 Pink
7 Red
8 Black
7
9 White
10 Blue
14
11 Grey
12 Purple
14 Black
* Includes Nissan Primastar
and Vauxhall Vivaro
= Handbrake output
= Can High
= Illumination output
= Steering control output
= Ignition output
= 12V+ input
= Steering control output
= Can Low
= Reverse output
= Speed pulse output
= Steering control output
= Ground input