JAQUE Line T393 Instruction Manual

1
Draw a horizontal line at H between 36" to 43" height. For
higher doors over 7´, necessarily use H:43". For doors
width less than 3´, cut the device to maintain the
minimum distance E: 1 ½".(See steps 5 to 7)
4
Dogging system: to undogg the push bar, turn a flat
screwdriver 90° clockwise; to dogg it, turn tool 90°
anticlockwise. Remove both front and rear caps. If cutting
is required, follow steps 5, 6 & 7. If not, go on with step 8.
7
Use a saw to cut rail case, bar and linking rod same
measure (a). This size is a= 3' – width of door. Replace
rear scissor, mounting bracket and linking rod; and
tighten grub screws.
10
Close the door. Check strike for its definitive position with
no gap between the roller and the latch bolt. Mark the
central hole, perform its drilling as indicated in the
template and place the central fixing screw. Verify normal
operation and finally place the cap. Note: Use this
installation also for double door with mullions.
Front Parts
PANIC DEVICE INSTALLATION
2
Align the template with the marked line and make the holes as
indicated by template panic device. Use scotch tape for fix the
template as shown.
5
Remove front nylon cover; slide push bar backwards and then
remove rear nylon cover. Lift and remove bar as shown.
8
Place the rail case on the door and fix it with only 2 screws (Parker
8x1/2" or W5/32"x1/2"), no adjusting at all. Be sure to have it
aligned and mark and drill the holes of the mounting bracket. Fix
with the remaining screws.
Panic device height projection (2 ½"/64mm)
Door application field: Single door (and double door
o only with mullions).
Max. Weight: 440lb. (200kg.)
Max. Height: 8'(2440 mm)
Max. Width: 4'(1220 mm)
Temperature: 14°F to 140°F (-10°C a 60°C)
Line T393: designed for panic door exit. For certificate and further
information, please visit our website.
Blincer S.R.L Calle 127 (Ombu) 1444- San Martin- Prov. Bs.As. (Argentina)
Phone: +5411 4712 5005 website: www.blincer.com
DESIGNATION OF PARTS
3
Apply strike on the frame door with screws and washers in
the sequence as shown.
6
Use a 2.5mm Allen wrench to loosen grub screws that hold
the linking rod to the front lever and the mounting bracket.
Slide these parts out of the rail case, keeping the front lever
fixed in its place.
9
Insert the push bar in opposite direction shown in 4. Place
and fix its covers and end cap. (See figures A and B).
"The safety features of this product comply with UL 305.
Any different alteration than the ones specified in these
instructions is forbidden".
Rear Parts
RECOMMENDATIONS
I393-01 REV.04 (11-2020)