FUTURE OCEANS Netguard Porpoise & Dolphin Pinger Attachment Instructions

Thank you for choosing Future Oceans Pingers.
Pinger Attachment Instructions
Leaving the electronics capsule in the housing,
thread 1 x cable tie through each hole at the ends
1
of the Pinger housing.
Use 7.5mm (width) x 200mm (length) cable ties.
Loop one end of the cable tie over the float or lead line
2
and feed cable tie back in to itself.
Pull cable tie closed firmly so the Pinger fits
3
closely to the float or lead line.
Repeat on the other end of Pinger. Pull cable tie closed
firmly so the Pinger fits closely to the float or lead line.
4
Both ends of the Pinger should be tight to the line.
Cut any excess cable tie to leave a clean finish.
Netguard 10 kHz Porpoise & Dolphin Pinger
Netshield 70 kHz Dolphin Anti-Depredation Pinger
Netshield 3 kHz Whale Pinger
= 1 Pinger every 100 meters
For Gill nets, purse seine nets and long lines.
Netguard 60-120 kHz Dolphin Pinger
= 1 Pinger every 200 meters
For Gill nets.
For Technical Assistance please email contact@futureoceans.com
Your Pinger is supplied with a battery, ready to use.
Simply follow the Pinger Attachment Instructions and start fishing.
electronics capsule
external housing
For further detailed instruction
please refer to Pinger instructions
on our website
www.futureoceans.com/pingers
Disclaimer: Diagram is for illustrative purposes only.
www.futureoceans.com