Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Waves SCHEPS 73
Summary of Contents for Waves SCHEPS 73
- Page 1 WAVES: ANDREW SCHEPS SCHEPS 73 USER GUIDE...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Chapter 1 – Introduction ........................3 1.1 Welcome ............................3 1.2 Product Overview ..........................3 1.3 About the Scheps 73 ........................4 1.4 Components ............................ 4 Chapter 2 – Interface and Controls ....................... 5 2.1 Interface ............................5 2.2 Controls ............................ -
Page 3: Chapter 1 - Introduction
Chapter 1 – Introduction 1.1 Welcome Thank you for choosing Waves! In order to get the most out of your new Waves plugin, please take a moment to read this user guide. To install software and manage your licenses, you need to have a free Waves account. Sign up at www.waves.com. -
Page 4: About The Scheps 73
1.3 About the Scheps 73 The Scheps 73 is a three band EQ, with a fixed high shelf frequency, a mid band with seven cutoff points (including the recently discovered 10kHz bell), a low shelf with four cutoff points, and a third order high-pass filter with four selected cutoff points. -
Page 5: Chapter 2 - Interface And Controls
Clip LED Pre-Amp On/Off VU Meters Calibration Drive On/Off Meter I/O EQ Mode Band On/Off Monitor Band Gain Band Frequency High Pass Filter Frequency Link I/O Phase Invert Input Faders Output Faders EQ In/Out Faders Link Waves Scheps 73 User Guide... -
Page 6: Controls
Range: On, Off Default: Off Please note: The Drive control turns the Scheps 73 into a distortion generator. This toggles the plug-in to a • state that emulates the insertion of a line level signal into the microphone preamp for distortion effects. - Page 7 Mono (stereo signal summed to mono) o Stereo o Right (right side only) • MS mode: o Mid (left plus right) o Mono (stereo signal summed to mono) o Stereo o Sides (left minus right) Waves Scheps 73 User Guide...
- Page 8 Clip Indicator indicates peak clipping and is located at the top right of the meter. It is almost invisible to the eye until it is on. Input adjusts input level pre-processing Range: +12 to -24 dB Deafult: 0 dB Output adjusts gain post plug-in processing Range: +12 to -24 dB Default: 0 dB Waves Scheps 73 User Guide...
-
Page 9: The Wavesystem Toolbar
Use the bar at the top of the plugin to save and load presets, compare settings, undo and redo steps, and resize the plugin. To learn more, click the icon at the upper-right corner of the window and open the WaveSystem Guide. Waves Scheps 73 User Guide...
Need help?
Do you have a question about the SCHEPS 73 and is the answer not in the manual?
Questions and answers