Advertisement
3.1.4.
firmly clamp the assembly together.
3.1.5.
switch on both lasers and observe the position of the projected beams in relation to the calibration marks at the head of the rig. see the
inset diagram in fig.2. if either of the beams are out of alignment they will have to be adjusted as described in the next section.
calibrating the lasers
3.2.
3.2.1.
firstly, remove the calibration shield from the laser that needs adjusting (see fig.3). undo the two socket cap screws that hold the shield in
place using a 3mm hex key.
3.2.2.
using the 3mm hex key loosen the laser pivot point just enough to allow the laser to pivot within the laser casing.
3.2.3.
loosen the laser adjustment point and, by sliding the screw head, move the laser in very small increments until the projected beam is
dead on the calibration marking on the rig head. if the beam needs to move to the right, slide the screw head to the left and vice versa.
3.2.4.
tighten the laser pivot point first.
3.2.5.
carefully tighten the laser adjustment point keeping an eye on the beam to ensure that the calibration does not change.
3.2.6.
fix the shield back in place and tighten the fixings.
3.2.7.
remove the laser units from the rig.
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMportant: no liability is accepted for incorrect use of this product.
WarrantY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
fig.2
Environmental protection
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
01284 757500
01284 703534
ms070cr | issue 3(l) 20/02/17
fig.3
www.sealey.co.uk
Web
sales@sealey.co.uk
Advertisement
