Cambridge Audio TOPAZ SR10 User Manual page 9

Speaker B connections
The Speaker B connections on the back of the amplifier allow for a second
set of speakers to be used (i.e. speakers located in another room).
The Speaker A/B button on the front panel and remote control allows the
two sets of speakers to be toggled on and off. Refer to the Front Panel or
Remote Control section of this manual for more information on the
Speaker A/B operation.
SR10
Manufactured in an
ISO9001 approved facility
CD
Left
Right
CD
Bi-wire connections
If your loudspeakers are equipped with two sets of terminals, then it is
possible to connect them in the bi-wire configuration. Bi-wiring sends the
bass and treble frequencies down separate speaker cables, resulting in
a clearer, more focussed sound.
Right
speaker
Speaker A
Main Room
FM 75Ω AM 300Ω Service Port
Loudspeaker Terminals
Impedance 4–8 ohms
Ground Right
A
DVD / BD Aux / MP3 Phono MM Out Rec
Left
B
Right
Right
BD / DVD MP3 / Aux MM Phono Rec Out
Speaker B
Room Two
Red Black Black Red
Black
Red
HF HF
LF LF
A
B
Black Red
Either A or B, or both A and B may be selected for use.
Note: When using two pairs of speakers, use speakers with a nominal
impedance of 8 ohms each.
Left
A
B
Left
Note:
– Speaker A and B must both be selected for this type of connection to
work.
– Remove the bi-wire link on the speaker terminals before connecting.
Refer to your speakers' manual for more information.
Black
Loudspeaker Terminals
Impedance 4–8 ohms
HF
Right Left
LF
A
B
Right Left
Black
SR10
Mains Voltage Selector Switch
115V/230V AC~50/60Hz
Power AC
Red
Left
speaker
HF
LF
Red
9