Related Manuals for PATROLLINE HPS 841 GSM
Summary of Contents for PATROLLINE HPS 841 GSM
- Page 1 8 4 1 G S M U S I N G I N S T R U C T I O N F R O M 1 5 . 0 7 . 2 0 1 0 N E W G E N E R A T I O N C A N B U S C a r a l a r m - A n t i t h e f t s y s t e m ,...
-
Page 2: Operation
Operation Operation ALARM SYSTEM ARMING Push the closing button of the default remote control. The activation will be confirmed by the followings: • Blinker flashing based on the closing features of the vehicle • 1 beep (if it is programmed) •... - Page 3 Inhibition time, status of alert After you switched ON the alarm with the default (OEM) remote control, the alarm will stay for 20 seconds into “neutral time” condition, signalled by the fixed light of the LED. The flashing of the LED of the dashboard will indicate that the system supervises the vehicle and is ready to signal the alarms.
-
Page 4: Memory Of Alarm
Warning! The exclusion of the siren is valid for only one cause of trigger! If you switch OFF the alarm with the remote control, the system will be restored automatically in the original state, and for the next switching ON it will react with beep and acoustic signals for every cause. IGNITION KEY Push the original remote With CDL open... -
Page 5: Safety Function
Safety function Door protection Door, trunk and bonnet open sense Engine block Prevent the start of the motor of the door Shock sensor Sense the broke of the door’s window Ignition protection Sense the ignition of the car Ultrasonic Option! Sense the moving in the passenger compartment Block the engine, if somebody wants to steal the car for ignition key Anti hi-jack ON case... - Page 6 2. or 3. emergency switch OFF operating mode instead of the default setting of the PIN code emergency switch OFF function! Only importer of PATROLLINE and his contracted partners can do the programming of the alarm, because special software and hardware is necessary to it! 1.
- Page 7 After that immediately you have to push/draw the brake pedal/hand brake as many time as the se- cond digit. After the LED switching OFF you have to push/draw the brake pedal/hand brake as many time as the third digit. If the procedure was successful, the alarm switches OFF. If the procedure was unsuccessful, the alarm stays in inhibition status, and triggers, by this time you have to restart the PIN code emergency switch OFF procedure from first digit giving of the PIN code.
- Page 8 If PIN code function of the alarm was programmed for brake pedal/hand brake mode, you have to do the above procedure on same way, only you have to push/draw the brake pedal/hand brake instead of turn ON/OFF the ignition key! WARNING! If the Antitheft / Antiagression function are programmed, before starting of the procedure, push the secret button used to the Antitheft / Antiagression, and keep it pushed until the procedure wasn’t finished!
- Page 9 2. Usage of valet function with ignition key (it is the default setting of the alarm, this function operates in that case too, if the PIN code emergency switch OFF function is program for 3. operating opportunity, the PIN code emergency switch OFF on ignition key ON, automaticaly operation): Activation of the Valet function: Deactivation of the Valet function:...
- Page 10 Operation of GSM PAGER During using of HPS 841 GSM PAGER, you can ask, get message for your telephone about the extant triggerings, switched ON / OFF status of the alarm, opened status of the vehicle CDL, or door, flat of the vehicle battery with calling and/or SMS.
- Page 11 Programming of GSM PAGER Programming of GSM PAGER The HPS 841 GSM PAGER is programmable with SMS. Firstly you have to program the telephone number with SMS, for which you would like to get the calling and SMS warnings. The following table contains which SMS commands, information asking are sendable for the alarm, and...
- Page 12 SMS-s sent by GSM PAGER által SMS-s sent by GSM PAGER által The HPS 841 GSM PAGER sends warnings with SMS too. The following table contains, what the warning SMS contains and it is in which case: The following table contains the English translation.
-
Page 13: Declaration Of Conformity
Low battery THE BATTERY VOLTAGE OF THE VEHICLE FALLED UNDER V FOR TIME MORE THAN MINUTES WITH SMS SENDING YOU SWITCHED ON THE SMS WARNING FUNCTION ABOUT OPENING OF THE Info enabled CENTRAL DOOR LOCKING OR THE DOOR WITH SMS SENDING YOU SWITCHED OFF THE SMS WARNING FUNCTION ABOUT OPENING OF THE Info disabled CENTRAL DOOR LOCKING OR THE DOOR AFTER THAT WITH SMS SENDING YOU SWITCHED ON THE SMS WARNING FUNCTION ABOUT OPENING... - Page 14 The following certification number has to be on the device, that it harmonizes with the conformity. E24 116R A-000018 Note: Patrolline Kft 8000 Székesfehérvár, Királysor 32. Tel/Fax: +36/22-317-367, +36/22-503-078 E-mail: info@riasztocentrum.hu Web: www.canbusriaszto.hu, www.patrolline.eu December 2010.