Using The Machine - Varan NEGJH-04 User Manual

Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
Working perimeter
1.
The area within a perimeter of 15m (50 It) of the person using the product should be
considered a hazardous area into which no one should enter. If necessary, yellow warning
rope, warning signs should be placed around the perimeter of the area. When work is to be
performed simultaneously by two or more persons, care should also be taken to constantly
look around or otherwise check for the presence and locations of other people working so
as to maintain a distance between each person sufficient to ensure safety.
2.
Check the condition of working area to avoid any accident by hitting hidden
obstacles such as stumps, stones, cans, or broken glass.
IMPORTANT : remove any obstacle before beginning work.
3.
Inspect the entire unit for loose fasteners and fuel leakage. Make sure that the drill
is properly installed and securely fastened.
STARTING THE ENGINE
1.
Keep bystanders and animals at least 15 m (50 ft) away from the operating
point. If you are approached, immediately stop the engine.
2.
The product is equipped with a centrifugal clutch mechanism, so the drill begins to
move as soon as the throttle lever is pulled.
3.
When starting the engine, place the product onto the ground in a flat clear area and
hold it firmly in place so as to ensure that neither the drill nor the throttle come into
contact with any obstacle when the engine starts.
Never place the throttle Into the high-speed position when starting the engine.
4.
After starting the engine, check to make sure that the drill stops moving when the
throttle is moved fully back to its original position.
If it continues to move even after the throttle has been moved fully back, turn off the
engine and take the unit to your authorized servicing dealer for
repair.

USING THE MACHINE

IMPORTANT: Drill only materials recommended by the manufacturer, and use only
for tasks explained in the manuaL
1.
Grip the handles firmly with both hands using your whole hand.
Place your feet slightly apart (slightly further apart than the width of your shoulders) so
that your weight is distributed evenly across both legs, and always be sure to maintain a
steady, even posture while working.
2.
Maintain the speed of the engine at the level required to perform drilling work, and
never raise the speed of the engine above the level necessary.
3.
If the unit starts to shake or vibrate, turn off the engine and check the whole unit.
Do not use it until the trouble has been properly corrected.
4.
Keep all parts of your body away from moving cutting attachment and hot surfaces.
5.
Never touch the muffler, spark plug, or other metallic parts of the engine while the
engine is in operation or immediately after shutting down the
engine. Doing so could result in serious burns or electrical shock.
NEGJH-04
WARNING
T: 00352/26908036 – F: 00352/26908040